It is currently Fri Dec 15, 2017 5:22 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 9 posts ] 
Author Message
 Post subject: Where can I get a couple of these clips?
PostPosted: Mon Apr 11, 2016 3:02 pm 
Offline
LOST Newbie

Joined: Thu Aug 13, 2015 10:35 am
Posts: 54
They are for the A/C lines and clip them to the top of the fan shroud area. Dealership only sells them with the purchase of a new line.Image


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Mon Apr 11, 2016 3:12 pm 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 3919
Location: Green Cove Springs FL
I used zip ties.

_________________
Bought my '05 CRD on June 2nd '07, used with 29,000 miles.
intake elbow and EGR delete. 7 volt Etecno glow plugs
Yeti stage 2 ECU tune. Straight pipe exhaust. DIY intercooler hoses
Provent and modified factory 180F thermostat
Replaced cylinder head (cracked) at 160,000 miles + ARP studs
Cheap 1 inch lift, 245-75R-16 tires.
Still love it.


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Mon Apr 11, 2016 5:30 pm 
Online
LOST Addict
User avatar

Joined: Sat Aug 24, 2013 11:36 pm
Posts: 3231
Location: Central GA
I used zip ties as well... :wink:
Mopar part number for clip is: 55037856AA

_________________
05 Jeep Liberty CRD Limited :JEEPIN:
Blk Brush Guard/Hella's/LED's
Ironman Springs/Bilstein's
Yeti Stg4 MaxTune
Weeks ElbowKit/Battery Tray
NO FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pump
2mic.Sec.Fuel Filter
Flowmaster/NOcat
V6 Airbox
GM11 blade fan/Hayden HD clutch
Ironrock Trilink
98 Dodge Cummins, 5"exh. Viair,K&N


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Wed Apr 13, 2016 7:05 pm 
Offline
LOST Member

Joined: Sun Nov 23, 2014 8:11 am
Posts: 108
Location: Virginia, west of D.C. / In the middle of moving to Roanoke
Zip-tied to what?

With my luck - I'd be inventive and zip tie the line at exactly the points with the maximum stresses involved.

:banghead:

_________________
'06 Liberty Limited CRD.
129,920 miles.
- Timing belt done.
- Weeks Kit Stage 1.
- Weeks Kit Stage 2.
- JBA 2.5 inch Silver kit and UCAs installed at 125K miles.
- Weeks supplied Samco Intercooler Hoses and clamps.


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Sat Apr 23, 2016 1:22 am 
Offline
LOST Member

Joined: Sat Jun 29, 2013 4:42 pm
Posts: 402
Location: San Diego, CA
Were those the clips that hold the AC line to the fan shroud?

_________________
2005 Liberty CRD Limited
DIY Garage Remanufactured Engine with GDE Full Torque Eco Tune from mile zero.
ARP Studs
Cummins Lift Pump
Transgo HD2 Reprogramming Kit
DIY Rebuilt Tranny Pump
Suncoast Torque Converter
2nd Generation Fuel Head
Sears P1 Battery
Hot Diesel Solutions Thermostat


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Sat Apr 23, 2016 10:35 am 
Offline
LOST Member

Joined: Mon Apr 26, 2010 10:06 pm
Posts: 161
Location: Southampton, NY
Zip ties...there's a coolant line right next to the a/c lines, there are also some existing holes on the a/c condenser. zip tie all that doo doo together and be done with it.

_________________
'05 CRD Sport, dark khaki w/ renny flares, GDE Eco tune, Weeks intake elbow kit, Samcos, Delphi lift pump, OME HD lift, Treadwright Guard Dogs or T/A's 245-75-16, Fumoto oil valve, 1.5" wheel spacers

In action on youtube: http://www.youtube.com/watch?v=8oCq4Xa1lH4


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Thu Jun 15, 2017 8:40 pm 
Offline
LOST Member

Joined: Tue Dec 16, 2014 9:33 pm
Posts: 244
Location: Jackson,TN
You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

_________________
05 Blu LIM, OME GDE Tbo, wk II,, 255/75/17 BFG Mud, KC Lights, bull bar, 161K H TC
05 Blu Lim, Dayton, GDE HT, 255/75/18 Dueler AT, 188K , H TC
06 Bla Lim, GDE Eco, Destination AT 245/75/17, 151K, H TC
06 D Khaki Lim 98K wkII Eur TC
01 F350 7.3L Du
CRDS: Fumoto, Kennedy Lift , Fan Shroud mod, fuel head, SAMCOS,self TB, 2 Mic filt, Hayden


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Thu Jun 15, 2017 8:50 pm 
Online
LOST Addict
User avatar

Joined: Sat Aug 24, 2013 11:36 pm
Posts: 3231
Location: Central GA
TKB4 wrote:
You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

Good advice; simple, quick, and cheap! :)

_________________
05 Jeep Liberty CRD Limited :JEEPIN:
Blk Brush Guard/Hella's/LED's
Ironman Springs/Bilstein's
Yeti Stg4 MaxTune
Weeks ElbowKit/Battery Tray
NO FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pump
2mic.Sec.Fuel Filter
Flowmaster/NOcat
V6 Airbox
GM11 blade fan/Hayden HD clutch
Ironrock Trilink
98 Dodge Cummins, 5"exh. Viair,K&N


Top
 Profile  
 
 Post subject: Re: Where can I get a couple of these clips?
PostPosted: Thu Jun 15, 2017 11:01 pm 
Offline
LOST Addict
User avatar

Joined: Sat Aug 27, 2016 9:12 pm
Posts: 1291
Location: N. Muddle Oregon Coast
TKB4 wrote:
You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

As Seen Here:

Image

Rt click, "View Image". Then you can zoom in and out for detail.

_________________
'06 Lbrty Sprt CRD 147Kmi

Sasquatch
DSS Turbo
CAT-elimntr
Weeks Stg1&2 EGRfix
PV-200
BLING
vent gauges

IDParts New
head
cams
rockers
Timing set
ARP studs
eTn1 GX2123 5v GPs

Flowmster 942550
Carter P76611M
GM 12611872
Hayden 2986
GM 15017911
2010 RamTrans
Sonnax 44957
Transgo kit
custom billet TC
Cooper 51770

Future plans: GDE Trans&Hot-tune


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 9 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com