LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
airbox mod http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=98&t=21828 |
Page 4 of 5 |
Author: | gmctd [ Sun Sep 30, 2007 10:48 am ] |
Post subject: | |
The Boost hoses are coated inside with the oil from the CCV blowby venting system - at first incident of blow-off, would be a good idea to pull them for a good cleaning with autozone engine cleaner, in the orange and white can - removes the oil and flushes clean leaving no residue Also, wipe the inside surfaces, then stuff rags into the compressor outlet and the inlet at the charge-air cooler and clean the outside surface of those tubes - dry everything, reinstall the hose(s) and torque the clamps - should hold them for another XX000mi Heads up: don't fergit to remove the rags B4 re-installing the hoses FYI - those pretty blue and exciting red silicone Boost hoses are an order of magnitude slippier than the rubber hoses when they become oil-coated - even slicker than owl snot. |
Author: | retmil46 [ Sun Sep 30, 2007 1:06 pm ] |
Post subject: | |
gmctd wrote: even slicker than owl snot.
My grandfather had a similar saying - except he usually referenced something that came out of the opposite end of the owl! |
Author: | gmctd [ Tue Oct 09, 2007 10:36 pm ] |
Post subject: | |
Yep - me, too - but the phrase I use makes my small grandson laff, and that's what it's all about, for now |
Author: | gmctd [ Sun Oct 14, 2007 1:00 am ] |
Post subject: | |
Got a chance to investigate the airbox 'dilema' today - - the CRD inlet configuration is similar to the V6 airbox inlet - at least two 90deg turns - with exception that the CRD is ahead of the front bulkhead right behind the grille, where the V6 is behind the bulkhead - the CRD config has a primitive centrifugal filter with the 'grille-shield' in place, in that the air takes a 90deg downward turn across the top of the grille, then another two 90deg turns to enter the airbox duct - the lighter component easily navigates the 90deg turns, the heavier component precipitates out - theoretically - the V6 snorkel, also with two 90deg turns, additionally has at it's inlet a 'precipitate' dam for a third 90deg turn, with the advantage of being further back behind the front bulkhead, where water, much denser than air, has additional obstacles for entrance, thereunto - unfortunately, the CRD c\f is more open at the bottom end than required for runoff, allowing entrance from the several lower angles also - hence, the dampening of the filter element in inclement weather |
Author: | retmil46 [ Sun Oct 14, 2007 11:29 am ] |
Post subject: | |
Another problem with the stock air intake - if you look, anything that blows in thru the gap between the headlight/foglight and the grille goes straight into the inlet tube for the filter housing - straight shot for rainwater, bugs, dirt, etc - completely negates all those baffles behind the grille. |
Author: | gmctd [ Sun Oct 14, 2007 11:16 pm ] |
Post subject: | |
Right - that back-door was inclusive - looks like they were trying to do something with the various pressure levels across the grillle - or, not - coulda been just for increased airflow - I agree - it is a problem |
Author: | rob103180 [ Sun Feb 15, 2009 12:13 am ] |
Post subject: | |
Search 53013108AA in Google and it should be the first result. |
Author: | CRD Joe [ Fri Apr 24, 2009 3:09 pm ] |
Post subject: | |
Glad I found this thread. Does the Amsoil EAA airfilter still work with this air box mod? |
Author: | 0311_DoC [ Fri Apr 24, 2009 3:15 pm ] |
Post subject: | |
CRD Joe wrote: Glad I found this thread. Does the Amsoil EAA airfilter still work with this air box mod?
yep that's what I use. it works in both air boxes its the same size |
Author: | CRD Joe [ Fri Apr 24, 2009 4:47 pm ] |
Post subject: | |
Thanks Doc. |
Author: | linewarbr [ Fri May 22, 2009 10:33 am ] |
Post subject: | Re: Gasser Airbox |
flatfender wrote: I talked to the parts man at www.moparsupercenter.com today and gave him the list of part #'s given on the forum to convert over to the gas airbox. He said that they have intended to make it a kit and he did that as I spoke with him on the Phone so all part #'s listed by oldnavy and others are now available as a complete kit on their website. Go to jeep select Liberty Air cleaners and the kit will pop up as sku # PKKJAIR. $88.60 plus shipping comes out to $101.00 with shipping to CA. Thanks again to all the forum members who did the foot work Later Flatfender.
I ordered this the other day and it was $109.41 before shipping to Baton Rouge, LA. Total cost $122.36 I like the idea of getting this in a package though, rather than individually ordering the parts. No luck locating a Liberty in a junkyard within a 3-hour drive. Here is the link to the package kit: http://www.moparsupercenter.com/liberty ... ml?cat=162 Will post when it comes in to update on quality of packing and product. |
Author: | CRD Joe [ Fri May 22, 2009 2:28 pm ] |
Post subject: | |
I got mine from a fellow LOST member for 100.00 total. A good deal. |
Author: | linewarbr [ Thu May 28, 2009 9:55 am ] |
Post subject: | Re: Gasser Airbox |
Quote: I ordered this the other day and it was $109.41 before shipping to Baton Rouge, LA. Total cost $122.36 I like the idea of getting this in a package though, rather than individually ordering the parts. No luck locating a Liberty in a junkyard within a 3-hour drive. Here is the link to the package kit: http://www.moparsupercenter.com/liberty ... ml?cat=162 Will post when it comes in to update on quality of packing and product. Received the kit in the mail yesterday, and I am very pleased. It was well-packed, and I was particularly impressed that the airbox included top and bottom as well as a new OEM (Wix) air filter. I still would have spent the same amount had I ordered just the parts and had to go buy a new filter to put in, so I am happy. I think it's neat to be able to just order a kit and be confident that you are getting the correct parts because of it.[/quote] |
Author: | CRD Joe [ Thu May 28, 2009 11:45 am ] |
Post subject: | |
Do you guys really think that air deflector is necessary???? |
Author: | nursecosmo [ Thu May 28, 2009 12:08 pm ] |
Post subject: | |
CRD Joe wrote: Do you guys really think that air deflector is necessary????
What air deflector? |
Author: | 0311_DoC [ Thu May 28, 2009 12:16 pm ] |
Post subject: | |
nursecosmo wrote: CRD Joe wrote: Do you guys really think that air deflector is necessary???? What air deflector? I think hes referring to the lil plastic piece that sits in front of the snorkel |
Author: | CRD Joe [ Thu May 28, 2009 12:50 pm ] |
Post subject: | |
0311_DoC wrote: nursecosmo wrote: CRD Joe wrote: Do you guys really think that air deflector is necessary???? What air deflector? I think hes referring to the lil plastic piece that sits in front of the snorkel Yep. Why block the incoming air? |
Author: | 0311_DoC [ Thu May 28, 2009 12:57 pm ] |
Post subject: | |
im thinking its more to block water and debris.. but being that it sits right where the hood comes down i don't see how much air even gets in there.... |
Author: | WolverineFW [ Thu May 28, 2009 6:14 pm ] |
Post subject: | |
0311_DoC wrote: im thinking its more to block water and debris.. but being that it sits right where the hood comes down i don't see how much air even gets in there....
Turbocharger sucks it in...... |
Author: | gmctd [ Thu May 28, 2009 10:01 pm ] |
Post subject: | |
Not an air deflector - water dam - dike - sea wall - whatever floats yer KJ........................ |
Page 4 of 5 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |