It is currently Fri Nov 24, 2017 4:25 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Need Help! Tranny in limp mode
PostPosted: Sat Jun 29, 2013 7:35 am 
Offline
LOST Newbie
User avatar

Joined: Fri Mar 15, 2013 7:12 pm
Posts: 50
Hey everyone, Carter here from BDS Suspension. We're in route to the start of this years Ultimate Adventure towing our 95% prepped KJ on 40s, but have a bit of a dilemma we were hoping you guys could help us get resolved. Drivetrain combo is CRD/45RFE/NP-241OR/JK Dana44s

We're having an issue with the tranny going into limp mode and believe its due to a wheel speed sensor issue. We robbed some off the front of another JK and wired them back into the harness but still going into limp. Heard the KJ OEM sensor used is based off the rear diff but haven't confirmed or had a chance to looking it. May try hooking one of the front sensors into the rear harness.

One thing we're still trying to work out is a wire coming out of the ABS module. With all the rerouting its a but cramped in there but there is a pink w/white stripe wire that comes out of the ABS module, need to know where it goes to.

Please help!


Top
 Profile  
 
 Post subject: Re: Need Help! Tranny in limp mode
PostPosted: Sat Jun 29, 2013 8:06 am 
Offline
Lifetime Member
Lifetime Member

Joined: Wed May 04, 2011 3:56 pm
Posts: 195
Location: Miami, Florida
From the information that I can remember reading about this topic (wheel sensors ). Some CRD'S came with three, other's four sensors. I know that most have one (just inside the fender liner) both front tire have them, and usually one in the rear which all transmit back to the ECU.

Some CRD's even read and transmit back a signal even for the spare tire like mine.

Pink wire with white stripe, FSM in the Sir Sam noob guide you would have to do some reading, or (Keith) at Green Diesel Engineering you could try reaching out to him.

Sorry, not to helpful but its what I can chime in.

_________________
2005 Jeep Liberty Limited CRD, JBA coilovers-4.5 Arms, 5xMoab's with 265-75-16 BFG Mud-Terrain KM2, Safari snorkel, Suncoast T/C, GDE Hot tune, Mandrel bent CAC Tubes, EHM to airbox, Mopar skid's, Fumoto Drain Valve, 3% Tint, ARB front bumper, Full set of Miller tools (9599) to loan within my immediate vicinity.


Top
 Profile  
 
 Post subject: Re: Need Help! Tranny in limp mode
PostPosted: Sat Jun 29, 2013 9:19 am 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Thu Dec 29, 2005 9:59 pm
Posts: 5157
Location: Austin, TX
PM GreenDieselEngineering - Keith knows these computers

his Web site has a phone number - but it says Mon-Fri
http://www.greendieselengineering.com/goPage.do?method=contact

normally the Forum can troubleshoot well - but you guys are on a deadline

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com