Vag-Com Beta 803.3 with interface HEX+CAN rs232 serial Version 702 software also workes. Will not work with their OPTO interface and or "freeware"
version"
Running in "Generic obdII mode"
Option 9, vehicle information, shows two controlers with the addresses of 12 and 41
Address 12 Corrieponds with the information on my ECM's tag
Address 41 Corresponds with the information on my TCM's tag but shows one rev newer
Also gives a 8 digit "verification" number for each controler.
The read data function gives MAP, rpm, % of load, TPS, RPM Temperature, Speed and more I'll add later
If there is a fault like for the MAF
I also get "unable to communicate with ABS controler" error but both will clear.
Error codes are given by name.
Last time I should have gotten a "low fuel (non Evic) I got a "tire low" message instead. Refueling shut it off. I think the BCM was confused.
Road testing results to follow. I did test it once and it quit responding.
I'll be playing with the latest release of VCDS and the hex/can usb tomorrow, I'll be sure to report back. I know it'll act like a generic reader; But if it can scan the modules themselves that would be cool.