LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Where can I get a couple of these clips?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=98&t=84424
Page 1 of 1

Author:  JAFO [ Mon Apr 11, 2016 3:02 pm ]
Post subject:  Where can I get a couple of these clips?

They are for the A/C lines and clip them to the top of the fan shroud area. Dealership only sells them with the purchase of a new line.Image

Author:  flash7210 [ Mon Apr 11, 2016 3:12 pm ]
Post subject:  Re: Where can I get a couple of these clips?

I used zip ties.

Author:  WWDiesel [ Mon Apr 11, 2016 5:30 pm ]
Post subject:  Re: Where can I get a couple of these clips?

I used zip ties as well... :wink:
Mopar part number for clip is: 55037856AA

Author:  crasher [ Wed Apr 13, 2016 7:05 pm ]
Post subject:  Re: Where can I get a couple of these clips?

Zip-tied to what?

With my luck - I'd be inventive and zip tie the line at exactly the points with the maximum stresses involved.

:banghead:

Author:  Mike92104 [ Sat Apr 23, 2016 1:22 am ]
Post subject:  Re: Where can I get a couple of these clips?

Were those the clips that hold the AC line to the fan shroud?

Author:  barley00 [ Sat Apr 23, 2016 10:35 am ]
Post subject:  Re: Where can I get a couple of these clips?

Zip ties...there's a coolant line right next to the a/c lines, there are also some existing holes on the a/c condenser. zip tie all that doo doo together and be done with it.

Author:  TKB4 [ Thu Jun 15, 2017 8:40 pm ]
Post subject:  Re: Where can I get a couple of these clips?

You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

Author:  WWDiesel [ Thu Jun 15, 2017 8:50 pm ]
Post subject:  Re: Where can I get a couple of these clips?

TKB4 wrote:
You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

Good advice; simple, quick, and cheap! :)

Author:  GordnadoCRD [ Thu Jun 15, 2017 11:01 pm ]
Post subject:  Re: Where can I get a couple of these clips?

TKB4 wrote:
You can also drill 2 holes in fan shroud like I did and run zip tie down in one and up through other and use it or better zip it there then leave it permanently and put another zip tie under it and up to lines and cut that one off any time you need access. then use new zip tie to easily replace it each time. I.E. a circle through a permanent circle.

As Seen Here:

Image

Rt click, "View Image". Then you can zoom in and out for detail.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/