Stiaanbreedt wrote:
Hi everyone
Not sure were to post
I am from South Africa and need advice on a 2006 Jeep Liberty 2.8crd
1. It droped a valve on piston no 1 when the timong belt was done it idles rough so i have disassembled the valve cover to find 2x broken rokers and the valve in piston no 1 head had droped into the cylinder pics to folow
2. I need advice on how do I loosen the cylinder head bolts as they seem to use an 7/16 socket if i am correct but they are stuck and wont budge , I am just afraid i might break them off
A long pull bar with a very good socket.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve