LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

2006 Jeep Liberty crd 2.8 droped valve piston no1
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=98&t=89440		 Page 1 of 1
Author:  Stiaanbreedt [ Tue Nov 13, 2018 12:59 pm ]
Post subject:  2006 Jeep Liberty crd 2.8 droped valve piston no1
Hi everyone
Not sure were to post
I am from South Africa and need advice on a 2006 Jeep Liberty 2.8crd
1. It droped a valve on piston no 1 when the timong belt was done it idles rough so i have disassembled the valve cover to find 2x broken rokers and the valve in piston no 1 head had droped into the cylinder pics to folow

2. I need advice on how do I loosen the cylinder head bolts as they seem to use an 7/16 socket if i am correct but they are stuck and wont budge , I am just afraid i might break them off
Author:  WWDiesel [ Tue Nov 13, 2018 3:59 pm ]
Post subject:  Re: 2006 Jeep Liberty crd 2.8 droped valve piston no1
Stiaanbreedt wrote:
Hi everyone
Not sure were to post
I am from South Africa and need advice on a 2006 Jeep Liberty 2.8crd
1. It droped a valve on piston no 1 when the timong belt was done it idles rough so i have disassembled the valve cover to find 2x broken rokers and the valve in piston no 1 head had droped into the cylinder pics to folow

2. I need advice on how do I loosen the cylinder head bolts as they seem to use an 7/16 socket if i am correct but they are stuck and wont budge , I am just afraid i might break them off

A long pull bar with a very good socket. :juggle:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/