It is currently Mon Mar 23, 2026 3:47 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 10 posts ] 
Author Message
 Post subject: CEL 200 miles after EGR Replacement
PostPosted: Wed Jan 17, 2007 7:37 pm 
Offline
LOST Member

Joined: Thu May 18, 2006 12:42 pm
Posts: 190
Location: West, IN
Just got the Liberty CRD back after the EGR was replaced and drove it about 200 miles only to get another CEL (MIL Code P0401) for Bad Flow (same as before) :shock: . They have ordered an EGR Flow Control Valve. The first order took a few weeks -- now this one hopefully will come in sooner :? .

Is this the way that most EGR repairs go -- two disassembly efforts for each repair? This makes for a fair amount of downtime for the vehicle (already more than my last three vehicles combined) :x . Ordinarily, I would put this down to incompetence of the dealership, but I'm beginning to suspect the manufacturer given how much discussion is showing up here and other forums :roll: .

_________________
Steel Blue 07 Jeep Grand Cherokee CRD :JEEPIN:
Mopar Skid Plates/GDE Programmer/Fumoto Oil Valve
80K+ miles & still smiling :D

Sold: Silver 06 Jeep Liberty Sport CRD


Top
 Profile  
 
 Post subject:
PostPosted: Wed Jan 17, 2007 7:41 pm 
Offline
LOST Member

Joined: Fri Dec 30, 2005 2:32 pm
Posts: 378
Location: Danville, Va
Welcome to the wonderful world of EGR failures. I have had 6 in 37k miles

_________________
O|||||||O

LOST #-169388
'79 CJ-5
32x11.50x15
304 V8

'08 Chevorlet HHR
Victory Red
Stock for now.


Top
 Profile  
 
 Post subject:
PostPosted: Wed Jan 17, 2007 7:56 pm 
Offline
LOST Member

Joined: Thu May 18, 2006 12:42 pm
Posts: 190
Location: West, IN
Yep, my first came at 6600 miles and I had 10K by the time they got the part in. Now, 200 miles later, it is getting comical. This would make a good Dilbert comic :lol: .

_________________
Steel Blue 07 Jeep Grand Cherokee CRD :JEEPIN:
Mopar Skid Plates/GDE Programmer/Fumoto Oil Valve
80K+ miles & still smiling :D

Sold: Silver 06 Jeep Liberty Sport CRD


Top
 Profile  
 
 Post subject: Re: CEL 200 miles after EGR Replacement
PostPosted: Wed Jan 17, 2007 8:51 pm 
Offline
LOST Addict
User avatar

Joined: Tue Jan 10, 2006 9:31 pm
Posts: 1406
Location: Camano Island, Washington
sbohner wrote:
Just got the Liberty CRD back after the EGR was replaced and drove it about 200 miles only to get another CEL (MIL Code P0401) for Bad Flow (same as before) :shock: . They have ordered an EGR Flow Control Valve. The first order took a few weeks -- now this one hopefully will come in sooner :? .

Is this the way that most EGR repairs go -- two disassembly efforts for each repair? This makes for a fair amount of downtime for the vehicle (already more than my last three vehicles combined) :x . Ordinarily, I would put this down to incompetence of the dealership, but I'm beginning to suspect the manufacturer given how much discussion is showing up here and other forums :roll: .


Mechanic at my dealership know that the flow control valve goes first, but DC makes him replace the EGR first. :roll: He don't understand why but he orders both and put them both on and write up same code coming up so he has them both cover. Some guys know how to play the game.

_________________
2006 Black Jeep Liberty CRD Limited
K&N, Samco Hoses, Michelin 245/70-16 LTX A/T2, Fumoto F-102, V-Force Muffler, Mopar, Hitch, Trailer Wiring, Skid Plates, Slush Mats, Rear Shelf, Predator Stage 1, Transgo, ORM & CodeReader, Facet 40109 Pump
"IT'S A DIESEL THING, YOU WOULDN'T UNDERSTAND"
Certified Services Auto & Truck Repair


Top
 Profile  
 
 Post subject:
PostPosted: Wed Jan 17, 2007 11:24 pm 
Offline
LOST Member

Joined: Thu May 18, 2006 12:42 pm
Posts: 190
Location: West, IN
Thanks BlackLibertyCRD,

I think I will pass that idea along to the mechanics down our way. I've been trying to get the folks at the Dealership to take a look at L.O.S.T -- perhaps good ideas like this will encourage them. Again Thanks!

_________________
Steel Blue 07 Jeep Grand Cherokee CRD :JEEPIN:
Mopar Skid Plates/GDE Programmer/Fumoto Oil Valve
80K+ miles & still smiling :D

Sold: Silver 06 Jeep Liberty Sport CRD


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jan 19, 2007 11:15 pm 
Offline
LOST Newbie

Joined: Tue Oct 31, 2006 9:23 pm
Posts: 46
sbohner wrote:
I think I will pass that idea along to the mechanics down our way. I've been trying to get the folks at the Dealership to take a look at L.O.S.T -- perhaps good ideas like this will encourage them. Again Thanks!


Which dealership do you use?


Top
 Profile  
 
 Post subject:
PostPosted: Sat Jan 20, 2007 12:37 am 
Offline
LOST Junkie

Joined: Fri Mar 31, 2006 7:52 am
Posts: 514
Location: Zionsville, IN
The same CEL will be thrown if it is truly the EGR OR the EGR Flow Control Valve (a.k.a Throttle Flow Valve).
DCX should replace them both at the same time as a preventative measure for not having to go back again.

_________________
2005 Black CRD Limited w/105,000 miles
Mann Provent 200, Airbox Mod, ORM Mod
New 545RFE, TC & Redesigned pump @ 25,020 miles
New EGR Flow Control Valve @ 25,020 miles
New Transfer Case input/output seals @ 32,787 miles
SEGR Kit @ 52,000 miles
SunCoast TC and Transgo Shift Kit @ 52,000 miles


Top
 Profile  
 
 Post subject:
PostPosted: Sat Jan 20, 2007 12:38 am 
Offline
LOST Addict

Joined: Fri Sep 16, 2005 2:01 am
Posts: 1944
Location: Mooresville, NC
Also, depending on how long you drove it after the EGR went south, you'll shortly get another CEL for one or more of the glow plugs going bad.

If this happens, word of advice - go ahead and pop for getting all 4 plugs changed out at once. Otherwise, you could be talking up to 4 separate trips to the dealer just to change glow plugs one at a time.

_________________
Mitchell Oates
'87 MB 300D Diamond Blue Metallic
'87 MB 300D - R.I.P. 12/08
'05 Sport CRD Stone White
Provent CCV Filter/AT2525 Muffler
Stanadyne 30 u/Cat 2 u Fuel Filters
Fumoto Drain/Fleetguard LF3487 Oil filter
V6 Airbox/Amsoil EAA Air Filter
Suncoast TC/Shift Kit/Aux Cooler
Kennedy Lift Pump/Return Fuel Cooler


Top
 Profile  
 
 Post subject:
PostPosted: Sat Jan 20, 2007 12:56 am 
Offline
LOST Member

Joined: Thu May 18, 2006 12:42 pm
Posts: 190
Location: West, IN
Hi Hokiecb,

I took it to the teh Duncan Jeep off of South main. Are you in the area? Perhaps we could talk sometime.

sbohner

_________________
Steel Blue 07 Jeep Grand Cherokee CRD :JEEPIN:
Mopar Skid Plates/GDE Programmer/Fumoto Oil Valve
80K+ miles & still smiling :D

Sold: Silver 06 Jeep Liberty Sport CRD


Top
 Profile  
 
 Post subject:
PostPosted: Sat Jan 20, 2007 1:00 am 
Offline
LOST Member

Joined: Thu May 18, 2006 12:42 pm
Posts: 190
Location: West, IN
Thanks DZL_LOU and Retmil46 for your observations. With the folks replacing the EGR control valve soon, if it happens again, I will suggest the glow plugs.

_________________
Steel Blue 07 Jeep Grand Cherokee CRD :JEEPIN:
Mopar Skid Plates/GDE Programmer/Fumoto Oil Valve
80K+ miles & still smiling :D

Sold: Silver 06 Jeep Liberty Sport CRD


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 10 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 89 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com