Rock Lizard Rear Bumper Install Instructions

unixxx · **Posted:** Mon Jul 23, 2007 1:27 pm

Does anyone know where I can find Marty's installation thread on the forum? Search isn't helping me....

pokefan · **Posted:** Mon Jul 23, 2007 1:43 pm

HERE'S the best I could find.

Rock Lizard · **Posted:** Mon Jul 23, 2007 2:49 pm

Here you go. I'm almost finished with them, so just refresh the page until they are complete. Should be plenty already to get you started.

http://www.rocklizardfabrications.com/k ... ctions.htm

0311_DoC · **Posted:** Mon Jul 23, 2007 2:52 pm

what about the 05-07 instructions? are they different?

Rock Lizard · **Posted:** Mon Jul 23, 2007 2:55 pm

0311_DoC wrote:

what about the 05-07 instructions? are they different?

exactly the same for all years 02-07.

Rock Lizard · **Posted:** Mon Jul 23, 2007 3:20 pm

OK, all done. If I missed anything, or if something is not clear enough, please let me know so I can make improvements.

JJsTJ · **Posted:** Mon Jul 23, 2007 3:54 pm

FWIW, I cut the notches but then just bent the sheet metal back, folding it up under toward the bolt holes and flattening it w/ a hammer. It fits and works fine and keeps you from cutting a chunk out of the rear pinch weld.

USAFCOP · **Posted:** Mon Jul 23, 2007 6:17 pm

RL Instructions:

Quote:

7. Support gas tank skid with jack, remove all 6 bolts (3 per side) with an 18MM socket, remove stock hitch if equipped. Forward most bolt on passenger side may need to be removed with an 18MM wrench if exhaust pipe is in the way.

Great excuse to buy a set of those ratcheting wrenches :twisted:

Works a lot easier than re-adjusting a standard wrench... Especially with as many times I have had to install and remove one of these :roll:

New tools are as good as well, nevermind...

Rock Lizard Rear Bumper Install Instructions

Who is online