DarbyWalters wrote:
When do you need funds? I think if people want the "big meal deal", they send the full amount to you and then you send the kits to UFO with a money order ($20.00/each) for the assembly ... just to keep things simple.
I'll send out Payment info around the 14th. I will order the pcb's also on the 14th and they will take 2weeks to have manufactured. So if everyone can get me their $ within a week of when I send out payment info that would be much appreciated. As for UFO's fee's, I have no problem with you guys paying me the extra and me forwarding the $ to UFO just make sure what all work you want done from him and the cost accordingly. Here is a quote from his post about his cost...
PCB Assembly $25, and I'll ship to the lower 48. You will still need to trim the wires and attach the crimps, and of course assemble the box. If someone can identify the optimum wire lengths for me, I will attach the crimps to the wire ends but not snap them into the connector (you need to attach the connector to the box first) for another $15
Please ask any questions you might have now as I had a few people bail out last time and leave me hanging, luckily there were people waiting to grab the extra kits I ended up with.
I now have over 4k on my ORM circuit or as some are calling it the "synthetic EGR mod" and my in town mileage is still better than it has ever been since putting the 255/70's on the rig. The extra pep also was noticed by the wife, who now seems alot more intrested in driving the little beast. Now if someone only made a decent bolt-on replacement for our oil spewing CCV's, but that another story.
_________________
2005 CRD Limited
1.5/2.0 Daystar Lift
V6 Airbox
SEGR ala TurboTim
255/70/16 Big O on Rubis minor trimming required
87k+ miles=3 factory TC's, 2 front pumps, 1 turbo, & drivers side wheel bearing/hub
Suncoast TC and Transgo Snake oil-41k
New Front Drive shaft-30K
Stage 2 InMotion Tune-54k, makes me go
B&M Tranny Cooler