I'm picking up a front skid, and need to buy the mounting hardware. What do I need to buy & can I get it somewhere other than a dealership?

_________________
2005 Liberty Sport 4x4

Frankenlift; Skink Sliders; Skid Row front skid; Mopar trans, t-case, and gas tank skids; f/r recovery points; Cobra 75 WX ST; Renegade light bar; hardwired radar detector; 245/75 Guard Dog MTs; Optima Red Top, Amsoil air filter

you can get the bolts at any hardware store i do believe, but not sure what size they are, but ill look for ya

I know the head is 15mm (at least mine is, I've heard others people have different sizes), not sure of the thread size.

_________________
2002 Jeep KJ Sport 3.7L 4x4

245/75-16 Mastercraft Courser HSX, 16x7 Cragar, 2" OME MD Lift, ARB Bumper
AEM Brute Force Cold Air Intake, Flowmaster Super 44 Muffler

Currently working on: Full service on transmission & bed-lining ARB bumper

viewtopic.php?f=43&t=84650

Don't you need nutzerts with that?

_________________
Mail Rated 2005 Red CRD Sport with large rectangular hole in top right behind the EVIC and above the heated leather seats.
2004 Jetta TDI

front bolts on , nuts already up in the frame, not sure an the rear as I just drilled and bolted mine on, much stronger

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

M10 with 1.5 pitch I THINK but its been a while since I replaced those bolts, the head does take a 15mm socket and you torque it to 45ft/lbs.

_________________
1980 Jeep CJ7 Buggy
SOA, D44/ FF14B, SBC 350, SM465, NP205, 108" WB, 37" MTs

http://www.dpgoffroad.com/
http://www.ucora.org/
http://www.christianoffroad.com/
http://jeepinbyal.com/

hey Joey, you are right!

i just looked it up on my .pdf and thats what it said M10, 1.5 pitch

You'll probably want washers too (I think they're attached to the factory bolts). Make sure you get the right grade of bolts. Should be marked 10.9 on the head. And the length I think is 30mm.

And don't get the ones that are only half threaded. You want fully threaded bolts like this: