Yeah, it's easy as that. These LEDs are set up to work with a 12 volt system, and draw little power, so pretty much plug and play. On my '07 Sport, it didn't come with the foot well lights, but the wiring is already there.. so all you have to do is tap into it and it works like factory.
Doing the puddle lamps are a little annoying, because you have to feed the wires through the door harness, take off the door panel and take off the mirror. A little time consuming. But not terrible. The only thing I would do differently is add another light to the inside of the door facing down, or at the bottom of the door. The LED on the mirror produces great light when you're getting into the truck. But when you're getting out, the light is on the outside, it doesn't illuminate where you will actually be stepping. Enough ambient light comes from the dome light so its not terrible, but while you're running wires and have the door panel off, might as well do it all at once.

Any other questions, let me know!

Oh and...



I'm not sure about the Liberty, if the cluster uses actual replaceable bulbs, or its on the circuit board. I know in the HVAC unit is is on the circuit board and not bulbs ( I think, lol )
My brother did this on his Dodge Van (which had replaceable bulbs that you can swap out), and it really didn't make a difference, if anything I like the the original bulbs better, probably because there was a bluish tint film to make the gauges that funny green/blue. Some bulbs were burnt out that's why he bought LEDs.. But as surfRenegade mentioned, the LED bulbs do not spread the light evenly enough, some places are noticeably darker than other areas.

was searching for the dome... and found this.
http://www.partstrain.com/store/details/Jeep/Liberty/Vision_X/Interior_Light/2005/Renegade/6_Cyl_3-dot-7L/VSXHIL-D6W.html
not a bad price!

The outback used a replaceable bulb in the cluster. Wedge base #194 is what the Outback took. since I never installed them I wonder if I can use them somewhere in the liberty. the LED's will replace #'s 194, 168, 158, 12256, 12961

This is what I have 4 of in cool white http://www.superbrightleds.com/cgi-bin/store/index.cgi?action=DispPage&Page2Disp=%2Fspecs%2Fwled-whp6.htm

_________________
2006 Liberty CRD Limited Deep Beryl Green Metallic Clear coat, Fumoto valve, MH ProVent (removed), GDE Eco tune,
OME 790/948 springs, OME struts, OME N132L shocks, Jeepin by Al A-arms, Hercules Terra Trac AT2 245/75R16
Weeks Stage 1 EGR delete, 5 volt steel glow plugs

just to make sure.. from the sylvania website, http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/AutoLRG-Results.htm "Map light-578 Dome light-578"
so therefore.... they would work like this for leds! http://www.v-leds.com/Interior-LED/DomeMap-LED/White-LED/SUPER-WHITE-9-LED-DOME-p4481172.html "SUPER WHITE 9 LED DOME LIGHT BULB 212 211 212-2 214-2 578"

please help me confirm, because I really want these leds!!!

oh I just looked it up in the manual

#168 bulb will fit in front side marker and rear license plate.

_________________
2006 Liberty CRD Limited Deep Beryl Green Metallic Clear coat, Fumoto valve, MH ProVent (removed), GDE Eco tune,
OME 790/948 springs, OME struts, OME N132L shocks, Jeepin by Al A-arms, Hercules Terra Trac AT2 245/75R16
Weeks Stage 1 EGR delete, 5 volt steel glow plugs

okay.. does anyone know where I can get the dome light plug with the wires?
should I just go to the dealer? i am adding another in there!
also... the 578's http://www.v-leds.com/Interior-LED/DomeMap-LED/White-LED/SUPER-WHITE-9-LED-DOME-p4481172.htmlwork? i am ordering this week... so i need to know

okay... got my leds installed tonight... omg they are bright!!!
problem is that 2 of the 8 on one are not working. I e-mailed the e-bay dude and we will see his response.


My question is, Has anyone replaced the 906... Step/Courtesy light with leds? I want to know a good brand to purchase from e-bay...

Rip got any pics?

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

I have sent them an e-mail and they said they will see if there is a quality check problem... but they said yeah we will send you new ones if they aren't correct.


so back to my new question...
My question is, Has anyone replaced the 906... Step/Courtesy light with leds? I want to know a good brand to purchase from e-bay... or should I just purchase 1 set of 15 strip leds?

rip they dont work cause you have the polarity reversed flip em

_________________
08 Revenge- Rock Lizard (Skink Sliders & Gecko Roof Rails), High Clearance Trimmed Front Bumper, Mopar skids, Riddler Diff Cover, JBA (5.5 Arms, 6" rear Springs, Front Adjust-A-Struts), 32" DuraTracs, Superior 4.56's, Front & Rear ARB Lockers, Fastman Throttle Body, AEM Intake, Hypertech Tune, Custom Ram Air, RunCool Louvers

They look good rip, also do they glow at all?

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

actually... if you flip them they don't work at all!
they do not glow, but I only have the front two in... eventually I will be getting the others though.


Has anyone replaced the 906... Step/Courtesy light with leds? I want to know a good brand to purchase from e-bay because I don't know if they will put off enough light...... or should I just purchase 1 set of 15 strip leds?

I ordered some similar to yours, I didn't like the ones I had installed in the overhead dome. I will update with pics as soon as they get here/

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

Has anyone replaced the 906... Step/Courtesy light with leds? I want to know a good brand to purchase from e-bay because I don't know if they will put off enough light...... or should I just purchase 1 set of 15 strip leds?

I would go with the LED strip

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

I just ordered some of these...
30 cm long

How much were those?

$1.00 gotta love hong kong!

haha, alright, definitely worth it, lol.