Ok This just started today. When activate the turn signals, sometimes they go into fast flash mode and the fronts dont flash anymore. Strangely the rear flashes ok. Flash rate is about twice as fast as normal. This happens about 50% of the time I use the signals.

Any idea whats going on?

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

try cleaning the contacts on the tail light bulbs

you're probably intermittently losing a bulb somewhere, or, your hazard/flasher unit is showing its grey hairs

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

If the front quit working I would replace the front bulbs and clean all contacts. My kj did the same thing with the brake lights not too long ago. One day all three brake lights just blew..

_________________
SOLD!!!
2005 Liberty Renegade
STT CustomSTUFF
4" Stump Lift.
JBA UCA's
245/75/16 GOODYEAR DURA TRACS


Thanks for throwing me under the bus Evil... Just remember this when you decide to turn yours back in to a... Real Jeep.

The faster flashing is due to not all the bulbs in that circut working,get the all the bulbs working and the fast flashing will go away.Same thing happens when you install LED bulbs without the resistors.