huntbuggy wrote:
Weak point of any hitch install is the bolts. Most aftermarkets from uhaul, drawtite and reese come with cheap 8.8 bolts. Definitely change them out for 10.9 for strength.
If you have a factory installed gas tank skid you might already have 4 out of 6 required 10.9 bolts in there as it is. (If you do have the skid note install is a bit trickier as the aftermarket hitches go over the skid and lining everything up can be a chore - easily rectified with a couple of jacks to hold everything where it should be when you bolt up).
If it's the tube steel hitch might want to clean it up and throw some paint on it, my last one rusted pretty bad - probably from the inside as water kept getting into the tube somehow. The square tubing Reese towpower type are open and water doen't hide anywhere but I regret not pre-painting mine a bit when I put it on new a couple of years ago as the places where metal on metal or rocks have occurred are rusting already.

Yeah the U-haul has a couple of rust spots and flaking paint/powdercoating (?), I'll take a small hammer to test and see if it's just some surface rust or if it's rusting from the inside out. If it's just rust from getting dinged up a bit then no worries but if I tap it with the hammer a hole appears then I'll pass.
If I do pick it up I think I may just wire wheel the rust spots and then hit it with some duplicolor rattle-can bedliner to freshen it up and keep the rust from coming back.