Geez I typed up a whole response and don't know what happened to it ?????
Anyhow this info gets me in the right direction but the colors in my harness have some different colors and one less wire than you have mentioned ?
now that you mention it I do remember that my switch did not have a Violet wire (to the low beams) but the diagram did.Here is my layout
Pin #1= blank
Pin #2= red/blue stripe
Constant HotPin #3= white/ tan stripe
to your lightPin #4= blk/ orange stripe
GroundPin #5= wht/blk stripe
Fused HotPin #6= orange
interior lightsPin #7= blank but there seems to be a spade in the actual switch
Pin #8= brwn/ yellow stripe
to bcmAlso you mention pin 19 in the bcm is this the harness that goes into the cluster?
here is the how to I followed: http://www.jeepkj.com/forum/showthread. ... +indicator Which pin # to illuminate the "rear fog" indicator as I see you have done (since this setup will be for the rear)
If I remember correctly there isn't an LED installed in the rear fog lamp indicator in the US models this is what I did- http://www.jeepkj.com/forum/showthread. ... ight=twist Where was this info located in the FSM ? I have the 06 fsm but can use your link to the other years if necessary
The wiring diagram I used was actually in the haynes and chiltons manualsThanks
Esteban