I've decided to go with a WARN removable winch mount for the XJ. I need some help figuring out the best methods to wire this thing front and rear.
Front Location:
Rear Location:
I haven't done any research, but I naturally like this setup:
Part Number: 37441 (12V)
Rated Line Pull: 9,000 lbs. (4080 kgs) single-line
Intended Use/Application: Vehicle Recovery / For Trucks and SUVs
Motor: 12V 4.6hp, Series Wound
Remote Control: Remote, 12' (3.7m) lead
Geartrain: 3-Stage Planetary
Gear Ratio: 156:1
Lubrication: Aeroshell #17
Clutch (freespooling): Sliding Ring Gear
Brake: Automatic Direct Drive Cone
Drum Diameter/Length: 2.5"/9.0" (6.4cm/23cm)
Weight: 104 lbs. (47 kgs.)
Wire Rope: 125', 5/16" diameter (38m, 8mm diameter)
Fairlead: Hawse
Recommended Battery: 650 CCA minimum for winching
Battery Leads: Front heavy-duty 7.5'/2.2m with quick connect plug
Finish: Argent Powder Coat
Option 2:
Part Number: 39116 (12V)
Rated Line Pull: 6,000 lbs. (2720 kgs) single-line
Intended Use/Application: Vehicle Recovery / For Trucks and SUVs
Motor: 4.8 hp, Series Wound
Remote Control: Remote, 12' (3.7m) lead
Geartrain: 3-Stage Planetary
Gear Ratio: 156:1
Lubrication: Aeroshell #17
Clutch (freespooling): Sliding Ring Gear
Brake: Automatic Direct Drive Cone
Drum Diameter/Length: 2.5"/5.0" (26.4cm/13cm)
Weight: 72 lbs. (31 kgs.)
Wire Rope: 50', 5/16" diameter (15m, 8mm diam.)
Fairlead: Hawse
Recommended Battery: 650 CCA minimum for winching
Battery Leads: Front heavy-duty 7.5'/2.2m with quick connect plug
Finish: Argent Powder Coat