My Jeep Build Update (OFFICIAL)

USAFCOP · **Posted:** Thu Apr 05, 2012 10:43 pm

I believe the filter is in the pump. YOu need to pull it out to get access to filter. As for the gas, try to plan it around an empty tank :roll:

teckman02 · **Posted:** Thu Apr 05, 2012 10:48 pm

blackwidowkj06 wrote:

ihatemybike wrote:

blackwidowkj06 wrote:

Still hunting for a replacement tailgate...

I found a few.
http://www.car-part.com

Yeah, already looked there. Not a single one in KY, well last time I looked there wasn't.

i know where there are 2 in KY

blackwidowkj06 · **Posted:** Fri May 04, 2012 10:45 pm

UPDATE

Haven't done much. Just graduates college with my AAS in Criminal Justice and looking for a job now. I did touch up my Herculine job and mounted my farm jack to the front bumper. Repositioned my foglights to the center of the bumper and spray painted the front end to clean that up a bit. I also reinstalled my skid plates a few weeks ago. Added a few more stickers for more HP. ;-)

blackwidowkj06 · **Posted:** Fri May 04, 2012 10:51 pm

surfRenegade · **Posted:** Wed May 09, 2012 1:36 pm

blackwidowkj06 wrote:

Your jeep is looking tough! I like it. This sticker cracked me up. Im an engineer for Honda and I still like it haha. Just dont think it would go over well on mine in the work parking lot :ROTFL:

blackwidowkj06 · **Posted:** Wed May 09, 2012 7:15 pm

surfRenegade wrote:

blackwidowkj06 wrote:

Your jeep is looking tough! I like it. This sticker cracked me up. Im an engineer for Honda and I still like it haha. Just dont think it would go over well on mine in the work parking lot :ROTFL:

Thanks it's one of my favorites. If I were you, I'd still slap that sticker on and show it off with pride!

Boomerang · **Joined:** Tue Jul 26, 2011 7:46 pm **Posts:** 184

I f'in love that sticker too!!!!!

but, i can't think of a worse place to mount the jack

blackwidowkj06 · **Posted:** Wed May 09, 2012 8:59 pm

Boomerang wrote:

I f'in love that sticker too!!!!!

but, i can't think of a worse place to mount the jack

the jack is fine where it is now. it has a purpose where it is now.

cgass · **Posted:** Wed May 09, 2012 10:19 pm

blackwidowkj06 wrote:

Boomerang wrote:

I f'in love that sticker too!!!!!

but, i can't think of a worse place to mount the jack

the jack is fine where it is now. it has a purpose where it is now.

A round here I see Jeeps with the jack mounted there all the time. It's either there or on the spare.

Oh, I like those Jeep decals on the hood too Sarah

CoopaTroopa · **Posted:** Wed May 09, 2012 10:30 pm

I think hes just concerned about it becoming a projectile during an accident. On a better note im looking at some trxus Mts for my jeep. Seeing yours and how much you like them I figured why not. Where did you get the Honda sticker?

blackwidowkj06 · **Posted:** Thu May 10, 2012 12:47 am

CoopaTroopa wrote:

I think hes just concerned about it becoming a projectile during an accident. On a better note im looking at some trxus Mts for my jeep. Seeing yours and how much you like them I figured why not. Where did you get the Honda sticker?

rather it hit something else, than the jack be inside the jeep and clunk me in the head if I rolled over...that jack is bolted on and locked on. it is not going anywhere.

interco trxus mts are an excellent tire for offroading. drive pretty good on the road. be ready to pay a pretty penny for the tires because they are expensive. i bought them from a member on here because 1) i needed new tires 2) it was a good deal for 4 tires/wheels plus matching spare. be ready for your mpgs to drop down and i hope you do not mind the "wha-wha" and roaring noise from mud tires.

the honda sticker was ordered from pixeldecals.com along with 3 other stickers.

blackwidowkj06 · **Posted:** Thu May 10, 2012 12:49 am

cgass wrote:

Oh, I like those Jeep decals on the hood too Sarah

If you want two for your KK, PM me for more details.

Boomerang · **Joined:** Tue Jul 26, 2011 7:46 pm **Posts:** 184

blackwidowkj06 wrote:

Boomerang wrote:

I f'in love that sticker too!!!!!

but, i can't think of a worse place to mount the jack

the jack is fine where it is now. it has a purpose where it is now.

as the bumper/rock chip collector

will be useless after a fender bender

blackwidowkj06 · **Posted:** Thu May 17, 2012 10:26 pm

Boomerang wrote:

blackwidowkj06 wrote:

Boomerang wrote:

I f'in love that sticker too!!!!!

but, i can't think of a worse place to mount the jack

the jack is fine where it is now. it has a purpose where it is now.

as the bumper/rock chip collector

will be useless after a fender bender

The jack is not my bumper. A rear TJ bumper acts my front bumper with the jack mounted to it. Pretty sure I wouldn't be crawling up rocks that come up to my bumper. Someone tried to play fender bender with my Jeep before and lost...very badly.

blackwidowkj06 · **Posted:** Tue May 22, 2012 3:25 pm

So today I bought a quart of Herculine bedliner to touch up some places and to bedline new places. :-)

I bedlined my tailgate because it was already toast from being rear ended back in March. A few of the pictures show how bad my tailgate is bent up. The front and rear bumpers were bedlined too.

cgass · **Posted:** Tue May 22, 2012 3:30 pm

The dent in your tailgate almost looks like a skull and cross bones. How is the bedliner holding up? Any fading?

blackwidowkj06 · **Posted:** Tue May 22, 2012 5:59 pm

cgass wrote:

The dent in your tailgate almost looks like a skull and cross bones. How is the bedliner holding up? Any fading?

It does. Really didn't see that till now.

Bedliner is holding up. It does loose the shine but tire foam cleaner shines it back up. I'm thinking a coat of clear coat would help.

blackwidowkj06 · **Posted:** Wed May 23, 2012 1:10 pm

Here are some close up pictures of Here are pictures of the bedline job I did on the Jeep yesterday. The pictures are in order of: front bumper, rear hatch, rear bumper, roof, roof rails.

Should I buy this? It's at Walmart for $40 and would be put to good use.

cgass · **Posted:** Wed May 23, 2012 1:33 pm

You're almost Diggerized now!! :JEEPIN:

blackwidowkj06 · **Posted:** Wed May 23, 2012 3:27 pm

cgass wrote:

You're almost Diggerized now!! :JEEPIN:

Yes I am. Thought about bed lining the whole Jeep. That would require atleast 3 gallons of Herculine (@ $90 per gal. w/ bed line kit), electric sander (because hand sanding would take a long time and I'd need to get it good) lots of prep time and labor just bed lining.

With that said, I am content with how the Jeep is bedlined now. No more for me!

I do have a couple ideas in mind for the Jeep.

My Jeep Build Update (OFFICIAL)

Who is online