Hello.
i have a problem, need to replace the outer cv boot of a JBA 3/8 cut axle.
It seem that there is no snap ring to release the outer joint from the axle like the normal Chrysler outer cv joint.
Is it press fit or something ?



this is the standard cv joint


JBA cv joint


Anyone did this kind of repair?
Also can I mix the two type of grease that black/grey from JBA and the greennish from Mopar?
Thanks

_________________
Libby 2004
Modified.

As far as boot replacement goes, check with the various auto parts shops.
You should be able to rent a tool which stretches a new "Stretch" CV boot
over the CV joint itself and then you just need to fasten it into place with a
new stainless steel CV clamp/tie.

thanks for the tip.

I'll check that in my area.

_________________
Libby 2004
Modified.