What have you done to your KK lately

Gageraid · **Posted:** Fri Nov 22, 2013 12:49 am

Why voltage? I used to watch GPH a lot, but have been using that slot for IAT :wink:

. TPS is a fun one for me.
So your goal should be to only fill up one time while on the road each way.

lfhoward · **Posted:** Fri Nov 22, 2013 9:06 am

Voltage lets me keep an eye on my alternator, and coolant temp on the engine's cooling system. I guess they are not critical because there are dummy lights on the dash, but it's comforting to make sure the Jeep is staying healthy. For voltage, I have a lot of gizmos that draw electricity to charge or run, including a heated seat kit. The coolant temp was important while climbing mountains and wheeling this summer, and is the main reason why I installed the mechanical cooling fan from the tow package.

Gageraid · **Posted:** Fri Nov 22, 2013 10:04 am

lfhoward wrote:

Voltage lets me keep an eye on my alternator, and coolant temp on the engine's cooling system. I guess they are not critical because there are dummy lights on the dash, but it's comforting to make sure the Jeep is staying healthy. For voltage, I have a lot of gizmos that draw electricity to charge or run, including a heated seat kit. The coolant temp was important while climbing mountains and wheeling this summer, and is the main reason why I installed the mechanical cooling fan from the tow package.

Good point about the voltage. I hope you get your KK in tip top shape for the trip.

Gageraid · **Posted:** Fri Nov 22, 2013 4:37 pm

Enjoying the new look without the side skirts.

At The Helm · **Posted:** Sat Nov 23, 2013 1:37 pm

Did some light desert wheeling/exploring around my house. Its beautiful out here in northern Nevada.

DirtyKK · **Posted:** Sun Nov 24, 2013 5:18 am

i miss snow... sometimes.

jjohnson1892 · **Posted:** Mon Nov 25, 2013 8:28 pm

I love your KK Morgan, and it looks really cool out there! Wish I could get out there some time but it's just a little far for me :oops:

Today I hauled some farm equipment and toys around. After work I got to cruise some farm roads and had my Jeep rallying down roads. Always a good time :lol:

Also started working on the switch panel wiring and fixing my CB wiring so hopefully I can have that in before the weekend!

Gageraid · **Posted:** Tue Nov 26, 2013 4:21 pm

Finally adjusted my hood. Without actually driving it, it seems like it should stop it from lifting up and shuddering at highway speeds. Who knows, maybe it'll even improve aerodynamics ever so slightly. :roll:

LKWJeeper · **Posted:** Tue Nov 26, 2013 9:13 pm

How'd you do that?

Sent from my SGH-T999 using Tapatalk

At The Helm · **Posted:** Wed Nov 27, 2013 1:21 am

JeeperSC wrote:

How'd you do that?

Sent from my SGH-T999 using Tapatalk

Under the hood there are two knobs you turn in or out according to how you want it adjusted.

Gageraid · **Posted:** Wed Nov 27, 2013 11:50 am

JeeperSC wrote:

How'd you do that?

Sent from my SGH-T999 using Tapatalk

Those "knobs" are right by the top of the grille when you open the hood.

Wearyman · **Joined:** Mon Aug 22, 2011 2:01 pm **Posts:** 161

Added a CB Antenna mount to my KK over the past weekend:

jjohnson1892 · **Posted:** Wed Nov 27, 2013 12:41 pm

Wearyman wrote:

Added a CB Antenna mount to my KK over the past weekend:

Just a heads up:

1) Watch your tailgate clearance with those screws. I had that mount on the other side and the screws on the outside (closest to the end of the taillight) hit my tailgate, took paint off, and started a rust war :oops:

2) If you take off your taillight (which is just two bolts and a good pull) you can wire the coax behind it and then go inside through a vent

Looks good though!

Wearyman · **Joined:** Mon Aug 22, 2011 2:01 pm **Posts:** 161

jjohnson1892 wrote:

Wearyman wrote:

Added a CB Antenna mount to my KK over the past weekend:

Just a heads up:

1) Watch your tailgate clearance with those screws. I had that mount on the other side and the screws on the outside (closest to the end of the taillight) hit my tailgate, took paint off, and started a rust war :oops:

2) If you take off your taillight (which is just two bolts and a good pull) you can wire the coax behind it and then go inside through a vent

Looks good though!

Thanks for the warning. That was one thing I was worried about. I selected that specific spot because the gap was large enough that the gate didn't hit. I have about 2mm of clearance there.

I was going to do the coax through the light, but I couldn't figure out how to get it through without taking of the interior paneling, and it was just do darn cold to want to go through all that effort at that point, so I just gorilla taped it in place and strung it through. It works OK, no pinching or leaking, but I plan on doing it properly once spring hits.

Bmxer524 · **Posted:** Thu Nov 28, 2013 1:46 am

I got an oil change and an alignment today. It should be ready for the hunting trip this weekend.

Oh and I met up with DoubleK since she was back on the island for Thanksgiving.

isomswim · **Posted:** Thu Nov 28, 2013 10:37 pm

Happy Turkey day to All.
Ordered some New rubber today.
Hankook Dynapro ATM RF10 235/75 r16
Then lift is going on as long as it warms up a little.

KKomodo · **Posted:** Sat Nov 30, 2013 9:38 pm

Just put the mt's on, will get pics tomorrow when its light

TrueTexUSN · **Joined:** Thu Jun 13, 2013 11:15 pm **Posts:** 104

Put my order in for Atthehelm front bumper! Super stoked! :BANANA:

lammarco · **Joined:** Sun Mar 18, 2012 3:37 pm **Posts:** 274

TrueTexUSN wrote:

Put my order in for Atthehelm front bumper! Super stoked! :BANANA:

Did you the winch or non-winch one? :jester:

TrueTexUSN · **Joined:** Thu Jun 13, 2013 11:15 pm **Posts:** 104

lammarco wrote:

TrueTexUSN wrote:

Put my order in for Atthehelm front bumper! Super stoked! :BANANA:

Did you the winch or non-winch one? :jester:

Winch one!

What have you done to your KK lately

Who is online