Over time the Jeep badge on my Liberty has faded. Rather than pry it off and replace it with a new one does anybody have any ideas? Maybe repainting it?
Or maybe I should go badge-less.


Sent from my iPad using Tapatalk

_________________
my trail & highway ride (and occasional tow rig)
04 Liberty Sport with a 2.5" lift, ProComp 245/75R16 AT's and two Hella700FF lamps (more accessories to come)

my trail queen
95 YJ with a RE 4" lift, 33" ProComp Extreme's, M8000 Winch, Lockrite Locker up front, Super35 in the rear and 4.88 gears

I'd bet if you removed them they might leave a "ghost" print behind. The easiest would be to replace it with a new one.

Sent from my LG-D801 using Tapatalk

_________________
2009 Jeep Liberty Sport Deep Water Blue
Skyjacker Coil Lift * 16x8 Cragar Soft 8s * 245-70-16 Cooper Discoverer HTP * Hypertech Econ Tuner * Renegade Headlights * RRO Roof Rails * Oscar Mike Decals

You could plast-dip it black to match your rims.

_________________
2008 Liberty Sport 4x4 Automatic

Jeepin By Al 4" Lift Kit
BFG KO2’s 245/75R16
Full MOPAR skid plates
Rock Lizard Skink Super Sliders
AtTheHelm Front Recovery System & Roof Rack
M116A3 Trailer build thread: viewtopic.php?f=72&t=77997

I just ordered replacement ones from amazon.$12

_________________
Outlaw KJ '04 4X4 v6 Sport
Frankenlifted front, custom springs 4" rear, 23.25" F/R - 265/75 Duratracs 16x7 D windows- JBA 4.5 UCAs, Y-link - AEM Brute Intake - Rockcrusher diff cover, Mopar Front Skid, All J belly skid, Skink Sliders - EBC Green Stuff F/R - DTT Front, 4.10s

Ahh...that's the look I'm going for.
I'll check the Amazon.ca site and see what they have.

But I'll probably just paint mine black.


Sent from my iPad using Tapatalk

_________________
my trail & highway ride (and occasional tow rig)
04 Liberty Sport with a 2.5" lift, ProComp 245/75R16 AT's and two Hella700FF lamps (more accessories to come)

my trail queen
95 YJ with a RE 4" lift, 33" ProComp Extreme's, M8000 Winch, Lockrite Locker up front, Super35 in the rear and 4.88 gears

I removed mine and didn't have a ghost print. Well at least after clay bar and waxing I didn't

Sent from my SAMSUNG-SGH-I537 using Tapatalk

I only assumed cause I've seen it on here before on an old KJ.

Sent from my LG-D801 using Tapatalk

_________________
2009 Jeep Liberty Sport Deep Water Blue
Skyjacker Coil Lift * 16x8 Cragar Soft 8s * 245-70-16 Cooper Discoverer HTP * Hypertech Econ Tuner * Renegade Headlights * RRO Roof Rails * Oscar Mike Decals

Most the time doing a clay bar and something like megs ultimate compound, then a good paste wax will get rid of it. Even if u can still barely notice it, it will go away with time

Sent from my SAMSUNG-SGH-I537 using Tapatalk

what is the best method to mask the letters off? tons of tiny pieces, it could take forever...

_________________
02 KJ Limited, 255 70 16 General AT2, Ironman Lift, JCR sliders, Mopar skids, radiator skid, LS/373 gearing, factory front hooks and rear hitch

92 XJ 4.0, AW4, NP242, 31s, 1.75 spacer, ZJ V8 coils, double cherokee leaf pack, 2 inch shackles, dnynomax exhaust, magnaflow cat, front hooks & rear hitch, gas tank skid, front skid, warn t-case skid

Exacto knife, masking tape, and alot of patience. Whatever you do don't try to pull them off to paint. They are somewhat soft and the letters deform and tear easily

Sent from my SAMSUNG-SGH-I537 using Tapatalk

Plasti dip and use a tooth pic to clean out the over spray and in between the letters.

Sent from my LG-D801 using Tapatalk

_________________
2009 Jeep Liberty Sport Deep Water Blue
Skyjacker Coil Lift * 16x8 Cragar Soft 8s * 245-70-16 Cooper Discoverer HTP * Hypertech Econ Tuner * Renegade Headlights * RRO Roof Rails * Oscar Mike Decals

That's what I did for mine. Plasti dip and a toothpick. Thick coats and about half an hour later you're golden

Sent from my HTC One using Tapatalk

_________________
2008 Black Liberty Sport 4X4 - Red and Black wheels and trim - Painted headlight bezels - Magnaflow Exhaust.

I have around 10 complete used emblems from later model Jeeps. All they need is new adhesive backing. Let me know if you need one.

I would tape it off and paint it black.

It would work since you have a silver body and black rims.

_________________
2004 Jeep Liberty Sport 4x4 "Slave II"

Black Mopar Jeep badges are not expensive, why would you paint it yourself? Look online.