I installed JBA's UCA on my 05 CRD and have had two intermediate axle shafts and cv axles.

After the first install I noticed a vibration but put off looking at the problem. After seeing the wear I guessed I has installed something wrong or it was just a worn 10 jeep with 155,000 miles on it.
Well, I changed this axle and cv out and in less than three weeks I am having the same problem.
I have the OME 1.5" lift. From reading on the forum. I understand that my lift is nothing to warrant the cut back axles that are available.

Is the new geometry causing this failure?

Thanks,

Tom




Sent from my SCH-I545 using Tapatalk
https://vimeo.com/156170993

_________________
2005 Jeep Liberty CRD Limited
Build Date May '05
OME lift kit
Samco hoses
Weeks Stage 1
PMF EGR plug kit
ARP Stud
Cracked CAC repaired with epoxy filler

Did you change the bearings and seals in the outer end of the diff? They were shot on mine when the intermediate shaft stripped.

_________________
Hers: 2005 KJ, V6/6spd/NV242J/3.73/posi, 2" Teraflex, ¾" cradle drop, KK forks, 22½" hub-to-flare, RRO arms, 245/75R16s, 260,000km
Mine: 1993 W250, Cummins/5spd/NP205/3.54, Lockright, ~3" lift, 315/75R16 Duratracs, extra smoke, more noise, 374,000km

No sir i didn't. Seal was dry. Needle bearing was fine too.

Thanks for the reply.

Tom

_________________
2005 Jeep Liberty CRD Limited
Build Date May '05
OME lift kit
Samco hoses
Weeks Stage 1
PMF EGR plug kit
ARP Stud
Cracked CAC repaired with epoxy filler