fortx4 KJ wrote:
I picked up a iro rear upper control arm. Does anyone have the dimensions on the bracket needed the attach this to a 8.25 rear axle? Thx in advance. I've use the search but couldn't get a messurement to fab up without mocking up myself.
The member that fabricated up a bracket to make the IRO work with a Jeep Liberty to the best of my memory never did share the dimensions for his bracket.
I believe he had plans to market it at some point, but due to liability concerns he got cold feet.
You could mock one up out of some heavy cardboard pieces, then using the patterns, cut the actual metal pieces, then drill all the needed holes, and finely weld it all together.
But it has got to be super strong!!!!
This is the thread with pictures where Whitby made the bracket to use the IRO arm:>
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=81761Later on in the same thread, on the next to last page, it is stated that Iron Forge Customs makes the bolt on bracket?
In the same thread, another member made this nice adaptor to use the IRO link but I believe it required welding the truss to the top of the axle tubes.
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=81761&start=200
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve