slasher wrote:
Ok guys long time member but new to this so need some advice please.
Read ECU via MPPS and have the following 107377513P53362K4, now I think that means I have the 513 software?
I have a P0610 code on my KJ, can I just upload the stock 513 file and clear the code using my reader?
Is it this easy or am I missing something?
Thanks in advance.
Jim
Have your tried clearing the code and see if it returns?
Yes you have 513 software version. What year is your Jeep?
https://www.obd-codes.com/p0610 wrote:
P0610 code definition
When the PCM (powertrain control module) or one of its supporting control modules detects a control module vehicle option error, it will detect and record a P0610 code. Once the code has stored, the Check Engine light will illuminate.
A stored code P0610 means that the powertrain control module (PCM) has detected an internal control module issue. The malfunction is related to the portion of the PCM that recognizes, monitors, and controls specific vehicle options. Each time the ignition is turned on and the PCM is energized, controller self-tests are performed. In addition to running internal controller self-tests, the controller area network (CAN) also compares signals from each individual module to ensure that the various controllers are communicating properly. If the PCM fails to recognize vehicle equipment options or if certain option characteristics do not match the vehicle identification number (and other protocol), a code P0610 will be stored and a malfunction indicator lamp (MIL) may be illuminated. Depending upon the perceived severity of the malfunction, multiple failure cycles may be necessary for MIL illumination.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve