I should be getting my tow hooks today and will be mounting them today or tomorrow but while I'm there I was thinking of trimming the bottom of the bumper off. I've seen it done a few times but was wondering if anyone has any pictures of the side of the bumper. I'd like to see how it's trimmed all the way around and what you guys did to make it look good instead of looking like someone just ripped it off.

_________________
-Gavin
2006 4x4 Sport ~ Dark Khaki
2.5" Rockfather II
Tow Hooks ~ HH Rear Hitch
Hella 500's

gwip Design

I'll take some pictures today or tomorrow. I removed the air dam and all the plastic between the two end caps.

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

[/img]

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

Sweet, that's what I'm thinking of doing! What did you use to cut it off? (Dremels Suck!! )

_________________
-Gavin
2006 4x4 Sport ~ Dark Khaki
2.5" Rockfather II
Tow Hooks ~ HH Rear Hitch
Hella 500's

gwip Design

A sharp knife

One of those folding razor blade knifes you can get at most hardware stores. I have dozens, keep them everywhere.

I did the trimming with the bumper off the KJ, but wouldn't be hard to do it if the bumper was mounted.

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.