PART 2, LIFT PUMP INSTALL
This drawing is the illustration of the lift pump install
This is a picture of the lift pump installed. Note the inline fuel filter before the pump.
This is the wiring connection to number 5 termnial of the relay and battery ground. I had to add one foot of wiring each because the wire on the pump are short.
The lift pump can also be install underneath near the fuel tank. This is a quick and easy way for those who want to install it and be able to take out without a trace in case of warrenty.
1 Install 2 elbows and 3/8 barr fitting to the lift pump
2 Remove 3/8 fuel hose from filter head
3 Install inline filter to fuel inlet line.
4 Install inline filter to lift pump using short hose from filter kit.
5 Install 3/8 fuel hose (about 18 inches in lenght) to outlet of lift pump and inlet of filter head.
6 Zip tie lift pump down to wire bundle behind battery. Note: Use a section of heater hose or some other material between the pump and wiring to protect the wire bundle.
7 Add about 1 foot of wire to each lead of the pump. Note: It is best to use connectors that are soldered.
8 Install an eye termnial to ground lead and strip 1.5 inch on positive lead.
9 Remove relay and install wire down in the #5 slot and run wire to the side so bare wire won't touch other termnials.
10 Install relay all the way in with the wire coming out of fuse block in the front, then run down the right side.
11 Install ground lead to negative battery termnial.
12 Make sure the bleeder valve is open on the bleeder kit.
13 Since the pump is mounted high we need to bleed it by pumping the plunger on the fuel head about 10 times.
14 Turn the key to on and the pump should run 30 seeconds bleed most of the air out. If pump don't run or keep running with key on engine not running the pump is hooked to the wrong termnial. Number 5 termnial is inside one of the two larger termnial.
15 Start the engine and let the pump finish bleeding. The pump should stay on when the engine is running. Now is a good time to check for leaks
16 Enjoy the lift pump and automatic bleeder mod.
Parts List:
1 Fuel Head Bleeder valve Kit,
http://www.lubricationspecialist.com/fr ... oductid=70
2 3/16 check valve.
http://www.usplastic.com/catalog/produc ... 5Fid=15641
3 Facet 40109 lift pump, available online
4 Two elbows, two 3/8 barb fittings and teflon tape. Home Depot, plumbing section.
5 Three feet of 3/8 fuel hose, Pepboys or Auto parts store
6 One foot of 3/16 fuel hose
7 Ten 3/8 hose clamps.
8 Purolator 3/8 inline fuel filters, This filter can be taken apart and cleaned when needed.
9 Two feet of # 16 wire and termnials and long Zip tie