LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

HiLift jack and Kit - any Reccomdations
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=10530		 Page 1 of 1
Author:  kjhawaii [ Mon Jul 17, 2006 6:28 pm ]
Post subject:  HiLift jack and Kit - any Reccomdations
Aloha

I want to buy a hilift Jack and kit. Any reccomendations or what not to buy???

I can get one fron Napa Autoparts for about $70

Image

Thanks in advanced

KjHawai
Author:  2006KJSPORT4x4 [ Mon Jul 17, 2006 7:18 pm ]
Post subject: 
not sure if you have a 4 Wheel Parts store out there or not but I know the one here in memphis was selling hi-Lift jacks for $50 last I was in there looking around....might wanna give them a looksey if you can.
Author:  Jeger [ Mon Jul 17, 2006 7:26 pm ]
Post subject: 
TSC had some for around $50. Again not sure if there are any near you or not.
Author:  valvestem [ Mon Jul 17, 2006 10:37 pm ]
Post subject:  hi-lift
To use a Hi-Lift jack on a vehicle, there must be a solid jacking point. The Liberty's jacking points are under the body, so the Hi-Lift would be of no use.
Author:  kolesy [ Mon Jul 17, 2006 10:50 pm ]
Post subject: 
Quote:
To use a Hi-Lift jack on a vehicle, there must be a solid jacking point. The Liberty's jacking points are under the body, so the Hi-Lift would be of no use.


Unless you got on some after market bumpers, or hitches
Author:  Jeger [ Mon Jul 17, 2006 10:57 pm ]
Post subject: 
kolesy wrote:
Quote:
To use a Hi-Lift jack on a vehicle, there must be a solid jacking point. The Liberty's jacking points are under the body, so the Hi-Lift would be of no use.


Unless you got on some after market bumpers, or hitches


Which obviously kjhawaii is working on

http://www.lostjeeps.com/forum/phpBB3/vie ... ht=#101460
Author:  Tokyojoe [ Tue Jul 18, 2006 12:14 am ]
Post subject: 
Nobody mentioned the size Hi-Lift. Aren't there like two or three sizes?
Author:  2006KJSPORT4x4 [ Tue Jul 18, 2006 1:20 am ]
Post subject: 
yea the price i mentioned was for a 48" sorry for not mentioning that before....
Author:  Wasatch15 [ Tue Jul 18, 2006 7:30 am ]
Post subject: 
Look into the Daystar anti rattle rubber piece that holds the jack handle from rattling and opening up accidently. You will want the 48" jack so you can store it under your back seat. Also look into a Jack mate to go with the jack in case you need to use it for winching, or at least the chain kit Hi-lift sells, and make or buy the off road wide base to use your jack in the mud. Look in the fabrication area and make yourself the bracket so you can lift the rear end too. Whatever you do, be very careful when using a hi-lift. With your front end brackets, how are you going to hook onto your front end in case you need a tow? Maybe you'll want to drill a 5/8" hole horizontal so you can install a receiver shackle, if the square tube is 2", just my .02. Good luck.
Author:  kj in a tight spot [ Tue Jul 18, 2006 5:08 pm ]
Post subject:  Re: hi-lift
valvestem wrote:
To use a Hi-Lift jack on a vehicle, there must be a solid jacking point. The Liberty's jacking points are under the body, so the Hi-Lift would be of no use.


Thats bogus. I used my Hi-Lift on my old KJ many times. You do need a bumper or BBs, but it can also be used as a hand winch and has multiple uses. Sayin its "useless" is not correct.
Author:  kjhawaii [ Tue Jul 18, 2006 10:22 pm ]
Post subject:  Thanks for all the input
Ok Ijust thought of something - The base does come off, or I have to completely rethink
this. I do not have one to compare it to. KjHawaii edit

Thanks All - I want to end this thread and point it to the fabrication section under "Custom Bumper/Hitch/Brushguard/Hitch Winch/Hi Lift Jack"

I found a 4wd shop an hour away that will get me the Hi-Jack in 3 weeks.I ordered the 48" X-treme. Its charcoal metallic and should somewhat match my bumper.

Image

The main member and possibly handle will be incorporated into my bumper. Im going to try to fabricate the "lift mate" for my wheels and put togather a minimized "hi-lift offroad kit" incorporating some long tow straps and some chain. Im passing completely on the electric winch since I probebly won't utilise it enough. And Im counting onthe hi-lifts abilities albiet more labor to get out (good for the soul). Im going for Efficienty Simplicity Practicality. Hope it works out.

Peace KjHawaii[/quote]
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/