You just have to yank it out. Don't worry you won't break it.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| tail light bulb replacement help needed fast!! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=11137 |
Page 1 of 1 |
| Author: | MattyMac1 [ Fri Aug 04, 2006 7:48 pm ] |
| Post subject: | tail light bulb replacement help needed fast!! |
how do you take the tail light housings off to get to the the bulbs. i took the screw out but its still stuck on there.i didn't want to snap anything.Tell me you dont have to take the plastic molding off in the inside.Help!! |
|
| Author: | warblade666 [ Fri Aug 04, 2006 7:56 pm ] |
| Post subject: | |
Each side has 2 screws, then they should rock outward (not strait back) that's it. |
|
| Author: | Jeepjeepster [ Fri Aug 04, 2006 8:04 pm ] |
| Post subject: | |
Take the screws out, pull straight back. They have extra clips to hold them in. |
|
| Author: | warblade666 [ Fri Aug 04, 2006 8:21 pm ] |
| Post subject: | |
Sorry, I thought they tipped outward. I have never had to do mine yet, I just thought they looked like the type that did. . |
|
| Author: | snowsport [ Fri Aug 04, 2006 9:03 pm ] |
| Post subject: | |
Those lenses can be STIFF the first few times you pull them off. I used a wedge to pry them out (CAREFULLY) and they just pop out. (after you undo the screws). |
|
| Author: | jeepkj02 [ Sat Aug 05, 2006 10:38 am ] |
| Post subject: | |
You just have to yank it out. Don't worry you won't break it.
|
|
| Author: | Jeepjeepster [ Sat Aug 05, 2006 10:54 am ] |
| Post subject: | |
warblade666 wrote: Sorry, I thought they tipped outward. I have never had to do mine yet, I just thought they looked like the type that did.
. Well, you can rock it out also. |
|
| Author: | AdamIsAdam [ Sun Aug 06, 2006 8:46 pm ] |
| Post subject: | |
Straight out. VERY hard the first time. My wife's MPV on the other hand, needed to go out by prying them outboard!. I tried pulling straight back and broke one! DOH! |
|
| Author: | MattyMac1 [ Sun Aug 06, 2006 10:13 pm ] |
| Post subject: | |
Hi yes they come straight out. they have 2 rivet type deals going into plastic clips on the body. I felt like i was going to snap something though. Kind of neat how the have the three individual bulbs that screw out with no wires on them. there is one main wire connector that doesn't connect to any lights just the housings.Thanks for your help. I went back out after the first post. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|