I just finished installing a Rockfather II lift using a 3/8" strut spacer on top of the strut/coil assembly. I was hoping for a level stance, however I still have the stock rake, lower in the front.
I was told I could go with an additional strut spacer for a little more lift in the front but that the stock bolts are too short.
Has anyone replaced these bolts with something longer? They appear to be pressed into the plate in some way. Can they be pounded out? Where can I get replacements that are up to spec and 1/2" or so longer?
Does anyone make a replacement for the entire plate with bolts only longer?

_________________
2006 CRD Sport
Rockfather II

they can be pounded out and put some longer ones in there

_________________
Richey

0IIIIII0
2006 IMPACT ORANGE RUBICON
305 Mt/Rs MT Classic II's
2.5 lift
1.25 JKS BL
JKS quicker Discos

Did you do a clevis lift as well? If not you can gain some more there.

_________________
LIBERTY or DEATH

2005 Sport with "STUFF"