I'm thinking of getting a set and was wondering how hard they are to install? I know they come with everything but you still need to go through the firewall and that scares me...

_________________
03 4X4 Liberty Sport, power everything but seats. head lamp rock guards, roof basket, Brite Box...Coming: LIFT and Bridgestone Revo's
The Jeep

ARL #KD7UBW

Member #RS057213

There are already holes in the firewall. Just find a spot where some of the stock wires already go through and fish yours through there.

_________________

As stated, u can fish thru the existing hole or u can get the remote wireless switches available so u don't have to fish wire and it has a keyfob u can take outta the KJ and turn on remotely

https://www.matrixracing.com/pc-11892-1 ... white.aspx

_________________
[_|_, [""""""]
l--- L---ollllllo-
( )_)-( )_)-o-)_) Liberator

....o_o_o_o
../| ,[_____],
|¯¯¯L--↨|||||||↨
()_)¯ ()_) ¯¯¯ )_)

(\__/)
(='.'=) <]{
(")_(")

( . )( . )

Hare on my Chest

Nothing to it. I just put on rear driving lights and getting the wires through was the easiest part of the whole install. Pop out the existing plug under the dash, bend a tight hook in the end of a straight piece of coathanger around your wires and push em through. Run around to the engine compartment and pull it right through! Only gotta pull off one piece of trim under the dashboard footwell and the plug is right there. There is a post on it around here someplace.....

http://home.comcast.net/~corwyyn/firewall-penetration.html

_________________
My pics!!
'03 Rennie w/all Tupperware
Custom Roof Basket
Mopar Tubular Brush Guard
Garmin GPS V & Laptop w/Nav software
RAM products laptop mount
Maglite w/mount
Rear cargo bay tool cabinet
AllJs Rear Shelf
Rear receiver
250k miles!
LOST #CR051230

Perfect...thanks. It's a birthday present for the boss... boy is she gonna be surprised.

_________________
03 4X4 Liberty Sport, power everything but seats. head lamp rock guards, roof basket, Brite Box...Coming: LIFT and Bridgestone Revo's
The Jeep

ARL #KD7UBW

Member #RS057213

Heres a link to a post over on KJ Country where I show some dimensions for drilling thru the bumper (if thats what you're going to do). Couple of notes: 1) come out another 1/4 inch from the grille so you can have some room to tilt the lights to aim them; 2) make sure you use some silicon or other sealer on the metal before you mount the lights. When I took mine off to do some work on the front end I noticed some rust on the bare metal edges of the holes I drilled.

_________________
Kevin
AD5VG
Just another red Jeep in the world...
L.O.S.T. #KB051963