LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

OTIS manual
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=14231		 Page 1 of 2
Author:  tomcater [ Tue Nov 07, 2006 6:31 am ]
Post subject:  OTIS manual
I managed to install my OTIS and it looks good.

Does anyone have instruction manual for the OTIS?
I'm looking to program the homelink function.

thanks all :lol:
Author:  eggwhite93 [ Tue Nov 07, 2006 9:21 am ]
Post subject: 
http://www.homelink.com/training/hlmanu ... 0homelink'
Author:  tomcater [ Tue Nov 07, 2006 5:35 pm ]
Post subject: 
thanks. :D

Do I have to calibrate the compass ? When I press and hold reset, it gives me "VAR" option with numbers 1-14. What's that for?
Author:  chetos [ Tue Nov 07, 2006 5:49 pm ]
Post subject: 
tomcater wrote:
thanks. :D

Do I have to calibrate the compass ? When I press and hold reset, it gives me "VAR" option with numbers 1-14. What's that for?


Tell me where you are and I can tell you which zone to pick.
Author:  tomcater [ Tue Nov 07, 2006 5:54 pm ]
Post subject: 
I'm in Toronto, Ontario, Canada :P

Thanks a lot
Author:  chetos [ Tue Nov 07, 2006 5:58 pm ]
Post subject: 
You look like your right on the line in the SM between 10 and 11. I could be wrong but looks closer to 11.
Author:  tomcater [ Tue Nov 07, 2006 6:02 pm ]
Post subject: 
hehe...
that's interesting....

I'm next to Buffalo, USA.

Does this help?

thanks for the help though 8)
Author:  chetos [ Tue Nov 07, 2006 7:17 pm ]
Post subject: 
what's wierd is the SM looks like 11 and the owners manual looks like 10. Probably can't go wrong with either.
Author:  tomcater [ Tue Nov 07, 2006 8:03 pm ]
Post subject: 
I'm sure it will not make a difference.

ANOTHER question :lol:

I followed the manual as mentioned above to program the homelink.

I pressed the two outside buttons, or the only one button with ignition on or off and nothing flashes and no icons appear.

Is there a trick outside from the manual ?
Author:  chetos [ Tue Nov 07, 2006 8:10 pm ]
Post subject: 
I just did this an hour ago.

Turned my KJ on--engine running
Pressed both outside homelink buttons until it said channels cleared.
held up garage remote to the lower left of evic
pressed garage remote and evic homelink button at the same time until the evic said "transmitting".
done.
Author:  tomcater [ Tue Nov 07, 2006 8:21 pm ]
Post subject: 
I guess EVIC and OTIS have the same procedures ? :oops:

thanks
Author:  eggwhite93 [ Tue Nov 07, 2006 9:12 pm ]
Post subject: 
Yes homelink is homelink
Author:  tomcater [ Tue Nov 07, 2006 9:13 pm ]
Post subject: 
Well I had the jeep running. It's a 2003 rocky mountain and a 2000 lhs OTIS overhead.

It has 3 buttons with 1 dot, 2 dots, and 3 dots.

I pressed # 1+3, 2+3, 1+2, for 20 seconds+ more without anything flashing.

Any ideas ?
Author:  chetos [ Tue Nov 07, 2006 9:16 pm ]
Post subject: 
tomcater wrote:
Well I had the jeep running. It's a 2003 rocky mountain and a 2000 lhs OTIS overhead.

It has 3 buttons with 1 dot, 2 dots, and 3 dots.

I pressed # 1+3, 2+3, 1+2, for 20 seconds+ more without anything flashing.

Any ideas ?


I pressed 1 and 3. Could take a minute or so????
Author:  tomcater [ Tue Nov 07, 2006 9:16 pm ]
Post subject: 
Hmmm....


Thanks. I'll try it :)
Author:  tomcater [ Tue Nov 07, 2006 9:27 pm ]
Post subject: 
Well I have tried every button and I don't get the flashing symbol

Here's a hint:

Every button I press, I get a sound, but when I press a Homelink button then I get no sound.

Is this normal ?
Author:  chetos [ Wed Nov 08, 2006 10:37 am ]
Post subject: 
I have been thinking about your issue. Could be one (or all) of a couple of things:
1. Homelink functions do not work on yours for some reason (worn out).
2. Not installed correctly?
3. Could be a glitch with crossing the brands. I had a 04 EVIC from a GC and it would always show right rear door open if that door was opened after the KJ was running even though it was firmly closed. I now have an EVIC from an 04 Libby and the only thing that doesn't work is the TPMS and that's just because I haven't bought the sensors yet. Maybe the Libby cpu is a bit touchy about other EVIC/OTIS???
Author:  tomcater [ Wed Nov 08, 2006 1:28 pm ]
Post subject: 
hmm....interesting

But is the homelink actually dependent on the Libby?

Isn't it its own system? In other words, does the Libby allow or disallow homelink to work?
Author:  tomcater [ Wed Nov 08, 2006 4:28 pm ]
Post subject: 
Here's another question:

The OTIS unit I bought had only the wiring harness to connect to the datalink connector under the dash.

Is there a separate antenna or something like that for the homelink?
Author:  chetos [ Wed Nov 08, 2006 4:33 pm ]
Post subject: 
I don't know how OTIS's are set up. My EVIC only has one wiring harness and another for the dome light. Other than that I am as lost as your are now. Sorry, maybe someone else can chime in. I am stumped!
Page 1 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/