If the bottom is flat, you have the 8.25.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| What rear end do I have? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=14336 |
Page 1 of 1 |
| Author: | N / A [ Thu Nov 09, 2006 8:13 pm ] |
| Post subject: | What rear end do I have? |
2002 Sport....what rear end is in it? |
|
| Author: | JJsTJ [ Thu Nov 09, 2006 8:36 pm ] |
| Post subject: | |
Most 02's came with the Corp. 8.25 w/ drum brakes and 29 spline axles. Some came w/ a D35 though rare. |
|
| Author: | moboden [ Thu Nov 09, 2006 11:14 pm ] |
| Post subject: | |
Hopfully you get a lot of nice rear end in your jeep! Sorry I coudn't resist. |
|
| Author: | N / A [ Fri Nov 10, 2006 10:48 am ] |
| Post subject: | |
how can I tell? |
|
| Author: | JJsTJ [ Fri Nov 10, 2006 11:25 am ] |
| Post subject: | |
Maybe this will help? http://www.getahelmet.com/jeeps/tech/axleid/ The 8.25 and D35 covers are very similar but the 8.25 is wider. |
|
| Author: | the1jferg [ Fri Nov 10, 2006 12:14 pm ] |
| Post subject: | |
Three rear axles: There was the 8.25 corp, The 194RBI (Dana 35), and the 198RBI (Rare super dana 35) Look for a "Dana" Diamond on the rubber fill plug, Diamond stamped on the cover somewhere, or a bar code sticker on the front drivers side of the axle, or a metal tag on the cover bolts with a bunch of numbers with "AF" or "AB" at the end of it. Hopefully you don't have the Dana for upgrade purposes. If you want strength, the 198RBI with a noslip (only option besides trac-loc) will get you where you want to go, the Mall parking lot will snap, craX, & pop your teeth out though!!!! Hopefully you have the corp Later |
|
| Author: | Jeepjeepster [ Fri Nov 10, 2006 12:39 pm ] |
| Post subject: | |
If the bottom is flat, you have the 8.25.
|
|
| Author: | CaKJFreedom [ Fri Nov 10, 2006 10:12 pm ] |
| Post subject: | |
And if you want to know everything your KJ came with you can go to Jeep's website and send them an email requesting your build sheet. I've heard you can get them from the dealer too. |
|
| Author: | Tomahawk [ Mon Nov 13, 2006 7:55 pm ] |
| Post subject: | |
You can get a build sheet from the dealer. Go into the parts dept and ask them to run it for you esp if you're looking for something specific. Make sure to have your VIN # handy. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|