I think 5.5mm,but I also think a 7/32 will work in a pinch.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Pillar Trim Bolt http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=15931 |
Page 1 of 1 |
| Author: | Danno [ Tue Dec 26, 2006 6:31 pm ] |
| Post subject: | Pillar Trim Bolt |
Does any one know what size the bolt is that holds the pillar trim on? The bolts that are underneath the grab handles? Tried all the sizes I had, but none fit. |
|
| Author: | Boi1ermaker [ Tue Dec 26, 2006 7:18 pm ] |
| Post subject: | |
i used a 7/32nd deep socket. I have a fair amount of tools, but i still had to make a trip to sears to get it. I think there is a metric size that works, but i couldn't find a post about it by searching the forum. |
|
| Author: | LiLredLibby [ Tue Dec 26, 2006 7:25 pm ] |
| Post subject: | |
I think 5.5mm,but I also think a 7/32 will work in a pinch.
|
|
| Author: | Danno [ Tue Dec 26, 2006 7:31 pm ] |
| Post subject: | |
Thanks guys, saves me from guessing and buying a set of sockets to get the right one.. A little broke due to the holidays right now. |
|
| Author: | chetos [ Tue Dec 26, 2006 8:43 pm ] |
| Post subject: | |
I bought a 7/32 deep socket for this for my EVIC instal. Too bad I won't use this again, probably... 
|
|
| Author: | Big D [ Tue Dec 26, 2006 11:26 pm ] |
| Post subject: | |
..best couple a bucks you've spent...................cheaper than replacing a broken A-pillar trim piece. |
|
| Author: | Danno [ Wed Dec 27, 2006 6:02 pm ] |
| Post subject: | |
I hear ya, I was half tempted to just to use a pair of long nose to get em out. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|