You need a nutzert like this if you are drilling a hole
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| nutzert question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=16103 |
Page 1 of 1 |
| Author: | chetos [ Tue Jan 02, 2007 6:54 pm ] |
| Post subject: | nutzert question |
OK maybe I am being dumb (yeah, probably). I just want to make sure I am doing it right. The nutzert has OD of 1/2". So I drill a half in hole and pop it in?? It does have a hex part closer to the end that is larger than 1/2" but I thought the principle was like an anchor where you put a bolt/screw in and it the sleeve expands. These don't look like they expand. Any help is appreciated. Thanks. |
|
| Author: | USAFCOP [ Tue Jan 02, 2007 6:59 pm ] |
| Post subject: | |
They should collapse/expand as you tighten down on them with a bolt while holding the nutzert. As for the size of the hole, I do not know. I know the All J rear rack instructions required a weird size hole just under the OD of the nutzert. |
|
| Author: | ATXKJ [ Tue Jan 02, 2007 7:24 pm ] |
| Post subject: | |
The nutzert goes into a hex shaped hole (the factory has them stamped into the 'frame') When you insert the nutzert - it should go all the way in so the the hex section is in hole - you then insert the bolt which expands the end and keeps it in place. |
|
| Author: | rs4mtnitro [ Tue Jan 02, 2007 7:44 pm ] |
| Post subject: | |
You need a nutzert like this if you are drilling a hole
|
|
| Author: | chetos [ Tue Jan 02, 2007 8:00 pm ] |
| Post subject: | |
rs4mtnitro wrote: You need a nutzert like this if you are drilling a hole
oops  good thing they're cheap and hadn't done anything yet...you got a part number for those?? thanks.
|
|
| Author: | rs4mtnitro [ Wed Jan 03, 2007 9:21 am ] |
| Post subject: | |
I don't have a part #, mine came with the plates but I have an '06 so I didn't need it. |
|
| Author: | W3CSX [ Wed Jan 03, 2007 12:01 pm ] |
| Post subject: | |
The part # is 06506644AA 
here is a thread on them http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=9417 |
|
| Author: | rs4mtnitro [ Wed Jan 03, 2007 12:08 pm ] |
| Post subject: | |
W3CSX wrote: The part # is 06506644AA
here is a thread on them http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=9417 If you noticed in the picture a round zert is needed not a hex. |
|
| Author: | chetos [ Wed Jan 03, 2007 12:44 pm ] |
| Post subject: | |
W3CSX wrote: The part # is 06506644AA
here is a thread on them http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=9417 I have those. I need the other ones. Thanks. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|