chetos wrote:
Just pull, it's clipped in.
More like yank on that sucker! Mine was tight. I thought I was going to break something when if finally popped loose. Be careful though and dont blame me if something does break.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| knee panel http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=17337 |
Page 1 of 1 |
| Author: | drossia [ Tue Feb 06, 2007 1:57 pm ] |
| Post subject: | knee panel |
How can I open/remove the knee panel on the driver side (05 model)? Sorry if this seems too naive, I just don't want to break something by just pulling too hard. thanks in advance |
|
| Author: | chetos [ Tue Feb 06, 2007 2:13 pm ] |
| Post subject: | |
Just pull, it's clipped in. |
|
| Author: | sleeve84028 [ Tue Feb 06, 2007 2:23 pm ] |
| Post subject: | |
two metal spring clips on the top of the panel. It's hinged on the bottom - so only pull from the top. |
|
| Author: | Jeger [ Tue Feb 06, 2007 2:34 pm ] |
| Post subject: | |
chetos wrote: Just pull, it's clipped in.
More like yank on that sucker! Mine was tight. I thought I was going to break something when if finally popped loose. Be careful though and dont blame me if something does break.
|
|
| Author: | dirtykj [ Tue Feb 06, 2007 4:03 pm ] |
| Post subject: | |
Pull hard. It's hinged on the bottom. If you pulled straight out it will probably pop off altogether, so kind of pull downward and it'll be fine. There is no wire attached to it at all. |
|
| Author: | drossia [ Tue Feb 06, 2007 5:03 pm ] |
| Post subject: | |
thanks for the tip. I'll give it a try |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|