LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Where to Install the Gauges Sensors
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=18608		 Page 1 of 1
Author:  SS-Virus [ Fri Mar 16, 2007 1:41 am ]
Post subject:  Where to Install the Gauges Sensors
Hi all,
I picked up a gauge pod long time ago, but I didn't have the time to install them, Yesterday I was trying to figure out where should the sensors connects to, I tried to go to one workshop, but they told that they didn't install one in LIBERTY before so, I went back home open the hood and try to find out a place to put them in with no luck, can you please help me,
I have two gauges one for Engine Oil temp. & one for Trans. temp.


Thanks
Author:  tjkj2002 [ Fri Mar 16, 2007 6:49 am ]
Post subject: 
The oil pressure sensor is right above the oil filter,you need to get a "T" adapter so you can use the factory sensor and the gauge sensor(you need the original sensor or engine will not run).As far as the trans temp gauge,that's a custom install.You can have a bung welded in the pan(best) or get a adapter that mounts it in a cooler line.Hope this helps.
Author:  sleeve84028 [ Fri Mar 16, 2007 7:36 am ]
Post subject: 
Yup - you'll need to drop the trans pan and clean it up. Then drill and install the supplied bung (or a seperate one that fits your sensor)

then reinstall, refill and run the wires back up to the gauge pod...
Author:  SS-Virus [ Fri Mar 16, 2007 10:38 am ]
Post subject: 
Thanks guys I sarted the insallation :)
Author:  RTStabler51 [ Fri Jun 08, 2007 11:06 pm ]
Post subject: 
were you successful in doing the t-fitting for the oil sending unit?
Author:  SS-Virus [ Sat Jun 09, 2007 4:23 am ]
Post subject: 
RTStabler51 wrote:
were you successful in doing the t-fitting for the oil sending unit?

I didn't hade a time to do it, when I install it I'll let you know.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/