| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Gear Ratio 02 KJ http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=22010 |
Page 1 of 1 |
| Author: | Fulltimer [ Tue Jun 26, 2007 5:58 pm ] |
| Post subject: | Gear Ratio 02 KJ |
What is the rear end ratio for 4Lo in 1st gear. With a V-6 Terry |
|
| Author: | tjkj2002 [ Tue Jun 26, 2007 7:03 pm ] |
| Post subject: | Re: Gear Ratio 02 KJ |
Fulltimer wrote: What is the rear end ratio for 4Lo in 1st gear. With a V-6 The rear end ratio is 3.73 for auto trannies(V-6).The t-case adds another 2.72:1 reduction in 4lo.
Terry |
|
| Author: | KY Liberty [ Tue Jun 26, 2007 7:08 pm ] |
| Post subject: | |
With the '02, 3.7 automatic, with the 45RFE transmission, NV242 or NV231 transfer case, and 3.73 gears, the final drive ratio is 11.19:1 in high range, and 30.32 in low range. Mine, with 4.10's is at 12.30:1 in high range, and 33.33:1 in low range. With the 42RLE transmission and 3.73's it 10.59:1 high range, and 28.71:1 low range. With 4.10's, 11.64:1 high, and 31.56 low. |
|
| Author: | Fulltimer [ Tue Jun 26, 2007 7:09 pm ] |
| Post subject: | Re: Gear Ratio 02 KJ |
tjkj2002 wrote: Fulltimer wrote: What is the rear end ratio for 4Lo in 1st gear. With a V-6 The rear end ratio is 3.73 for auto trannies(V-6).The t-case adds another 2.72:1 reduction in 4lo.r Terry Is that for the 02? I have an 05 now but I used to have the 02. It seems that the 02 was a lot lower than my 05. Terry |
|
| Author: | Jeepjeepster [ Tue Jun 26, 2007 7:12 pm ] |
| Post subject: | |
The tranny had a lower 1st gear in the 02.. rear diff and tcase is the same. |
|
| Author: | tjkj2002 [ Tue Jun 26, 2007 7:13 pm ] |
| Post subject: | Re: Gear Ratio 02 KJ |
Fulltimer wrote: tjkj2002 wrote: Fulltimer wrote: What is the rear end ratio for 4Lo in 1st gear. With a V-6 The rear end ratio is 3.73 for auto trannies(V-6).The t-case adds another 2.72:1 reduction in 4lo.r Terry Is that for the 02? I have an 05 now but I used to have the 02. It seems that the 02 was a lot lower than my 05. Terry |
|
| Author: | Fulltimer [ Wed Jun 27, 2007 5:09 am ] |
| Post subject: | |
Thanks guys. That clears it up! I like the 02 set up better. Terry |
|
| Author: | KY Liberty [ Wed Jun 27, 2007 12:53 pm ] |
| Post subject: | |
Fulltimer wrote: Thanks guys. That clears it up! I like the 02 set up better.
Terry I like the '02 setup better too. Just wish it had the 2nd overdrive ratio of .67 like the 545RFE for the interstate. |
|
| Author: | Fulltimer [ Wed Jun 27, 2007 12:59 pm ] |
| Post subject: | |
Would switching the tranny work or would the computer have fits? Terry |
|
| Author: | tjkj2002 [ Wed Jun 27, 2007 1:14 pm ] |
| Post subject: | |
Fulltimer wrote: Would switching the tranny work or would the computer have fits? Well the 45RFE has a seperate TCM unlike the 42RLE has the TCM intergrated into the PCM,so yes the PCM would have a fit.
Terry |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|