| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rear hitch bolt sizes? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=22578 |
Page 1 of 1 |
| Author: | pokefan [ Mon Jul 16, 2007 5:59 pm ] |
| Post subject: | Rear hitch bolt sizes? |
Anyone know the correct size bolt for a rear hitch? Thanks |
|
| Author: | tjkj2002 [ Mon Jul 16, 2007 8:37 pm ] |
| Post subject: | Re: Rear hitch bolt sizes? |
pokefan wrote: Anyone know the correct size bolt for a rear hitch? 12x1.75(metric),any length between 1 1/2"-2" long.
Thanks |
|
| Author: | pokefan [ Mon Jul 16, 2007 11:32 pm ] |
| Post subject: | |
hmmm... Should I be concerned? I ended up getting 7/16 course thread and they fit perfect. I even had to clean out a couple of the threads to get them to screw in any farther. There was absoulutely NO play in them when I tested. |
|
| Author: | tjkj2002 [ Tue Jul 17, 2007 7:04 am ] |
| Post subject: | |
pokefan wrote: hmmm... I would be since the they are supposed to be metric,plus 7/16" is equal to 11mm,so the 7/16" bolts are a 1mm to small in diameter and you have rust just holding them in and they could pull out at anytime.
Should I be concerned? I ended up getting 7/16 course thread and they fit perfect. I even had to clean out a couple of the threads to get them to screw in any farther. There was absoulutely NO play in them when I tested. |
|
| Author: | Tokyojoe [ Tue Jul 17, 2007 8:31 am ] |
| Post subject: | |
Take the original (if you have a gas tank skid) bolts in to Lowes or Home Depot to test them on those bolt boards to know what threads you have and then get some slightly longer. So, the hitch made it to you? |
|
| Author: | pokefan [ Tue Jul 17, 2007 9:32 am ] |
| Post subject: | |
Yep, got it and installed it last night. Thanks! I don't have any skids at the moment so I don't have any bolts to compare to. TJKJ - I made sure all the threads were cleaned (wire brush & air) out before I installed every thing and didn't see any rust at all. As I said before it was a snug fit. I'm not saying I don't believe you by any means cause you definitely know more then I do but I would think if the bolts were a mm to small there would be a little play in them when they were screwed in. I'll have to go get some 12x1.75 bolts and compare them this weekend and see what works. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|