Anyone know how to remove the plastic on the interior of the swing gate? I want to check on my rear-wiper motor, my spare tire mount bolts and whatever is back there. When driving, there's an annoying rattle coming from the swing gate and I want to at least see if I can do something to help/fix. Any help on how to remove and reinstall that plastic interior piece of the swing gate would be greatly appreciated!

_________________
2003 Limited, Silver - L.O.S.T. # 068957 Rockies
http://www.cardomain.com/ride/2127390/14
2006 Kawasaki KLR650

I was told once by a smart man that there are a series of clips along the perimeter of that piece. You can start near the latch area and pop them with a little bare hand force, or with a long screw driver.

I never did get around to popping mine off to fix a hole in the plastic...

_________________
'04 Renegade 4x4
L.O.S.T. #058466
Car Domain, Updated: 2/23/2009
===_oooo
(_l_|_,\____\,_
{----__---_(olllllllo)
()_)"""""()_)--"--)_)

yea, its held on by plastic clips that break easily.. The dealer broke some of mine when they did the recall for the rear flipper glass.

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

yeap plastic clips is all. just lightly pull at the edges and it's easy to see where they are at. if you pull straight up/out where the clip is, it will reduce the chaces of it breaking. Pulled the plastic off mine multiple times without any problems.