| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| New Grille for 07 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=23398 |
Page 1 of 1 |
| Author: | WoodysKJ [ Mon Aug 13, 2007 1:21 pm ] |
| Post subject: | New Grille for 07 |
Took a rock off a dump truck on the expressway Friday and put a chip in the chrome grille just under the driverside headlight, Was gonne loose the bling anyway so i tried this.Just did this over the weekend. I had to go to the stealership for the door handel thing this morning and they went nuts. THEY LOVED IT!!  
Herculiner! Door Side moldings are next, Bye Bye Bling. Anybody know how to remove the side moldings on an '07 with out killing them? |
|
| Author: | bugnout [ Mon Aug 13, 2007 1:24 pm ] |
| Post subject: | |
Can't tell, is that bedliner, undercoating or hammer look paint? Interesting look |
|
| Author: | WoodysKJ [ Mon Aug 13, 2007 1:27 pm ] |
| Post subject: | |
Herculine Bed Liner Quart Can at PepBoys, 26.00. |
|
| Author: | Boi1ermaker [ Mon Aug 13, 2007 2:00 pm ] |
| Post subject: | |
Quote: Anybody know how to remove the side moldings on an '07 with out killing them?
Guy over at jeepKJ did basically the same thing with his '05, except he painted instead of Herculined: http://www.jeepkj.com/forum/showthread.php?t=27456 |
|
| Author: | hyedipin [ Mon Aug 13, 2007 2:29 pm ] |
| Post subject: | |
Very cool, now, we are going to wait for another rock to crack your bumper, so you can do that as well! 
Did you sand it before or did you simply spray it on the grill? |
|
| Author: | WoodysKJ [ Mon Aug 13, 2007 2:40 pm ] |
| Post subject: | |
Sanded the hell out of it and rolled it on with the roller sold by Herculiner. About killed myself sanding that thing, but really roughed it up |
|
| Author: | dirtykj [ Mon Aug 13, 2007 3:11 pm ] |
| Post subject: | |
Can you detail how you removed the grille? I can't find the places to remove screws from, besides the top three and the tabs around the bottom. |
|
| Author: | bugnout [ Mon Aug 13, 2007 3:19 pm ] |
| Post subject: | |
As I recall, there are no screws, it has 3 or 4 tabs and in the middle and two latches near the headlight. Other than that there are tabs at the bottom that just slide out once the top is loose. thats it. |
|
| Author: | WoodysKJ [ Mon Aug 13, 2007 3:44 pm ] |
| Post subject: | |
bugnout wrote: As I recall, there are no screws, it has 3 or 4 tabs and in the middle and two latches near the headlight. Other than that there are tabs at the bottom that just slide out once the top is loose. thats it.
correct, no scews on mine, tabs on both headlights, 2 tabs on either side of hood latch. use a slotted screw driver slide under tab and squeeze the two pieces together and GENTLY pry it ou. will pull forward and then lift out. RE install is reverse, WATCH OUT ON THE SIDES where the fenders are and the contact with the grille, can scratch. |
|
| Author: | Maximum Carnage [ Mon Aug 13, 2007 4:25 pm ] |
| Post subject: | |
I have an 02 and it has four screws on the top 
|
|
| Author: | WoodysKJ [ Mon Aug 13, 2007 4:35 pm ] |
| Post subject: | |
02-04 with step down bumpers have screws, 05-07 with flat top bumpers, no screws |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|