Try torquing them to the correct specs (upper 100, lower 85)

I put new ends on my jeep, and not 3 hours later the noise came back. I kept asking myself "is it really possible that I killed new sway bar end links in 3 hours???"

Today it dawned on me, check the torques dummy. The passenger side was perfectly fine. The driver side upper was perfectly fine. The driver side lower just needed to be turned two or three times till I got to 85 ft/lbs.

Voila. Noise is gone. I guess it's time to pick up some thread locker...

_________________
Have fun out there.

2003 Cactus Green Renegade w/ NP231 & NV3550
Al's 4th Gen UCAs
Custom 3.5" Lift
Rear DTT
Spidertraxed 245/75/16 Maxxis Bighorns

I was having some noises from them and thats all mine needed too. Just gotta torque them good and they are fine.

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster