I have after-market heating units installed in my cloth Sport seats, driver and passenger. These were installed by the dealer when I bought the Jeep new over 2 yrs ago. These have a hi/low setting toggle switch, both were mounted on the centre console in the space between the window controls and shifter. As of right now my drivers side does not work. Passenger side is all normal. I thought it was a lose connection but all seems fine. HAd the dealer have a tech take a look during its last oil change 2 weeks ago. They said they checked it out, all looked fine to them. It worked for a few days, even though right now weather doesn't warrant using it I kept checking to ensure it was repaired. Eventually the indicator light on the switch started to go deem and eventually went out, again no heat. I have pulled apart the top part of the center console to take a look at the swtiches connections, all seem ok and same under the seat, from what I can see (not that I could tell what connection goes to what exactly
). If I fiddle with the connection under the toggle switch, I can get the indicator light to come on, faintly, but again it eventually looses the conection and no more heat.
I'm trying to avoid having the dealer look at it again but that may have to happen. Any advice would help guys. I hope this all makes sense
.
