LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

washer fluid resevior
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=25883		 Page 1 of 1
Author:  bearmedic [ Sat Oct 27, 2007 2:19 pm ]
Post subject:  washer fluid resevior
im thinking bout pulling the washer fluid resevior and just fill a spray bottle with windex and and my nephew on the hood think dot will allow it???????

nah but seriously the darn thing is to low any body remove theirs? or modify it to be smaller?
Author:  tommudd [ Sat Oct 27, 2007 2:28 pm ]
Post subject: 
Lots of people have moved to one under the hood, using an overflow jug as the new one, several posts about doing it just look
Author:  carroll952 [ Sat Oct 27, 2007 2:50 pm ]
Post subject: 
This is what alot of folks have done. Nice writeup by Matt.

http://www.lostjeeps.com/forum/phpBB3/vie ... her#187707
Author:  Pablo [ Sat Oct 27, 2007 4:05 pm ]
Post subject: 
I have a CRD, so there is no room to relocate this. I am considering buying an extra stock one from the junk yard and operating on it. I am not sure if the bottom of the design is long enough to permit this, but if it is a straight box for long enough , you could cut it in half across, insert the bottom of the box back into the top-- collapse it inward and then JB weld it back together, now much shorter. Then it should fit in the stock location with more clearance.
Author:  bearmedic [ Sat Oct 27, 2007 6:42 pm ]
Post subject: 
i htough bout doing that to but if i remember correctly the last time i had my bumper off the thing was an awkward shape. I even though bout taking a 3liter coke bottle and thowring it wiht the pump actually in teh bumpper and run a long hose lol .
drew
Author:  0311_DoC [ Sat Oct 27, 2007 11:27 pm ]
Post subject: 
Pablo wrote:
I have a CRD, so there is no room to relocate this. I am considering buying an extra stock one from the junk yard and operating on it. I am not sure if the bottom of the design is long enough to permit this, but if it is a straight box for long enough , you could cut it in half across, insert the bottom of the box back into the top-- collapse it inward and then JB weld it back together, now much shorter. Then it should fit in the stock location with more clearance.


well let us CRD folks know what you find out. im putting on my TR bumper next week and i know that bottle is going to be an eye sore. I gotta figure out something...
Author:  JHCRASH [ Sat Oct 27, 2007 11:49 pm ]
Post subject: 
bearmedic wrote:
i htough bout doing that to but if i remember correctly the last time i had my bumper off the thing was an awkward shape. I even though bout taking a 3liter coke bottle and thowring it wiht the pump actually in teh bumpper and run a long hose lol .
drew

HMMMMM. I wonder if this is something that could be done if one were to have the after market bottle in hand before the bumper was built :?: :wink:
Author:  bearmedic [ Sun Oct 28, 2007 5:32 am ]
Post subject: 
i dont see why you couldnt do it,
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/