LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Received my 2003 evic ????????
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=29957		 Page 1 of 1
Author:  splash [ Thu Feb 28, 2008 2:43 pm ]
Post subject:  Received my 2003 evic ????????
I bought a 2003 evic for my 2003 renegade.
But i didn't receive a piece of wire with it!

Where can i get this piece of wire?
Only at the dealer???

Thanks

terry
Author:  Uffe [ Thu Feb 28, 2008 4:59 pm ]
Post subject: 
Heh. That piece of wire is part of a harness. The harness is probably not cheap, but the dealer will be able to get it for you.

Also try a wrecker.
Author:  chrisroth1 [ Thu Feb 28, 2008 9:41 pm ]
Post subject: 
you don't need that wire, go find an old computer (or a maybe the one you are using if you don't have an old one) cut the floppy power cable off your power supply, your probably not using it anyway, make sure you leave some wire on it and make your own harness by just extending the wire. after you make it to the length you want wrap it completly with electric tape so it won't rattle in your in headliner/ everywhere else it goes. the pins just about line up with the floppy cable you may need to bend them slightly but it works great. if you want an orginal harness i think it goes for about $1000 from the dealer cause it has a lot of other things attached, you can make your own for about $5, free if you have the wire around already.
Author:  Sir Sam [ Thu Feb 28, 2008 9:47 pm ]
Post subject: 
just solder on some wires to the pins.
Author:  Uffe [ Fri Feb 29, 2008 3:53 am ]
Post subject: 
Great idea with the floppy connector! Why didn't I think of that myself?!
Author:  splash [ Fri Feb 29, 2008 12:16 pm ]
Post subject: 
Ok!!! I don't know nothing in computers!!

Where is the floppy cable located?

And any pics if possible?

Thanks

Terry
Author:  splash [ Sun Mar 02, 2008 6:35 pm ]
Post subject: 
I oppened up my computer and took out the floppy connector
It connects right on the evic.
Now i just need to know, where to go hook up the wires
And also need to know which pin does what on the evic so i
can plug the wires in the good places.

Here are pics.ImageImage

Thanks terry
Author:  Uffe [ Sun Mar 02, 2008 7:05 pm ]
Post subject: 
Image

That should help you just a bit.

Also check out to see where the wires go in the ODB-II port:

http://www.jeepkj.com/evic/
Author:  Littlehorn [ Mon Mar 10, 2008 4:26 pm ]
Post subject: 
I can't tell you for sure...but I think the 2003 KJs have the pigtail you need up in the headliner just waiting for an EVIC. The harnesses were the same for all of the models but the pigtails are stowwed for the models without installed EVICs.

Chris
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/