Rusty's lift & 245/75 Super Swamper IROKS
smashed the pinch weld & had to do some inner fender modification for rubbing & STILL have to trim more
but it comes with running these tires so it's all good
oh & rims are 16x7 with 4 inch BS
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Lift & tire question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=30280 |
Page 1 of 1 |
| Author: | Jeep Dawg [ Sat Mar 08, 2008 5:18 pm ] |
| Post subject: | Lift & tire question |
OK I am actually gonna do my FrankenLift tomorrow. I am going to still use my bfg's 225/75/16 on for now because they still have half life on em. This will give me time to ebay more stuff and save for new tires. What size tires are you lifted guys going to. And who is beating their pinch welds I have the 03 sport and Installing the Frankenlift II |
|
| Author: | Fulltimer [ Sat Mar 08, 2008 5:24 pm ] |
| Post subject: | |
Frankenlift II Premium getting 265/70/17" Destination M/T or same size MTR's Pinch weld already pounded overr. Bottom of front bumper trimmed also. Terry |
|
| Author: | Prometheus Xray [ Sat Mar 08, 2008 5:26 pm ] |
| Post subject: | |
245/75/16 on 16x7s. 31" tire with a 4" BS on cragar soft 8s. Practically no rubbing, and if u beat the pinch weld down ull be totally fine. |
|
| Author: | tommudd [ Sat Mar 08, 2008 5:43 pm ] |
| Post subject: | |
If you stay around a 30 inch tire like a 245-75X16, then it will not affect your gas mileage quite as much as going to a 31/32. Doesnt seem like much but it is, esp. if you are using it as a DD. Plus articulation is good , just not as many problems. |
|
| Author: | _UnLiMiTeD_ [ Sat Mar 08, 2008 7:37 pm ] |
| Post subject: | |
do they make a 255/75 tire? i have never heard of anyone running it. I have heard 245/75, 255/70, 265/70, 265/75 but never 255/75; seems it may not cause as many problems as the 265 tires, but still get the height and a bit extra width. |
|
| Author: | raceinfan [ Sat Mar 08, 2008 7:50 pm ] |
| Post subject: | |
Rusty's lift & 245/75 Super Swamper IROKS
smashed the pinch weld & had to do some inner fender modification for rubbing & STILL have to trim more but it comes with running these tires so it's all good
oh & rims are 16x7 with 4 inch BS |
|
| Author: | dloc_jeep_KJ [ Sat Mar 08, 2008 7:55 pm ] |
| Post subject: | |
Rustys lift 3 ring clevis 1 rear iso and im running 245/75/16 MTRs. i have no pinch weld hammering or finder trimming but at full lock in reverse i have some rubbing. its not bad though but i do plan to trim it up some when it warms up a little. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|