Hi:

I recently picked up my new CRD. I orderd it with the factory tow package.

Yesterday, I installed the ball mount I had used on a previous vehicle and noticed that it fits extremely loose and therefore rattles...

Has anyone else had this problem? Any good solutions?

The MOPAR hitch I have must be metric, because the two inch hitch rattles real bad when the utility trailer is empty.

Al

_________________
One Ruby, One Grand Cherokee, One YJ, One disassembled CJ, one Chevy Mason dump, one hotrod IH Pick-up, couple of antique tractors.
Former owner of a 5.5 inch lifted KJ

http://www.hitchcorner.com/pintle_hooks.htm#anti-rattle

I did find the anti-rattle device about for on the www... might work.

I have this little gaget from Cabela's. It works fine. Just mount it upside down due to limited bumper clearance.

http://www.cabelas.com/cabelas/en/templates/links/link.jsp?id=0009871520365a&type=product&cmCat=search&returnString=hasJS=true&_D%3AhasJS=+&QueryText=hitch+anti+rattle&_DARGS=%2Fcabelas%2Fen%2Fcommon%2Fsearch%2Fsearch-box.jsp.22&Go.x=0&Go.y=0&N=4887&Ntk=Products&Ntx=mode+matchall&Nty=1&Ntt=hitch+anti+rattle&noImage=0&returnPage=search-results1.jsp

_________________
JacksJeep
Lifted, Locked and Ready to Wheel

Metric hitch, huh? Hehe..

_________________
Jeremy - Aurora, CO
L.O.S.T. #0

Future:
2016 Hydro Blue JK Unlimited Rubicon Hard Rock

Previous:
2012 Flame Red JK Unlimited Rubicon - Sold!
2012 Flame Red JK Unlimited Rubicon - Dealer buyback
2003 Silver KJ Freedom 4x4 - Sold!
32s, Frankenlift, BBars, onboard air, dirt.
KJ EVIC Install