| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| I remember seeing a write up of how to install http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=3208 |
Page 1 of 1 |
| Author: | BlueFreedom [ Thu Nov 03, 2005 2:59 pm ] |
| Post subject: | I remember seeing a write up of how to install |
a rocky-road tranny skid. Anyone know where it is? Thanks in advance! BlueFreedom |
|
| Author: | deserthorizons [ Fri Nov 04, 2005 11:48 pm ] |
| Post subject: | |
I used to have a write up on the install.. apparently that is one of the few pics I never saved.. If you already have purchased the skid, it is fairly easy to install.. If you have not purchased the skid yet, do not buy the RRO.. Get the one from Boulder Bars if they have a version for your year.. I know you need to drill a "hole" on the drivers side of the stock engine skid to get it to fit, other than that it is just 4 bolts.. |
|
| Author: | JacksJeep [ Sat Nov 05, 2005 8:10 am ] |
| Post subject: | Install |
Assuming that you have the skid row product that RRO sells, all that is needed is to enlarge the bolt hole of the factory dif skid (driver's side, rear). The factor skid plate is angled to follow the contour of the frame. The RRO skid slightly changes the angle that the bolt goes through the hole in the frame. The is why you need to enlarge the hole in the factory skid. You should have a longer bold and nut for this hole. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|