LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

back seat gone
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=34248
Page 1 of 1

Author:  Freshmud [ Sat Jul 19, 2008 5:54 am ]
Post subject:  back seat gone

has any one just had one of those couple days were you have so much going on at once you wanna flip a lid? Well its that time of the year for me :( ..... My mom replaced some new appliances and sullied my garage with her garbage so i cant work on my kj in there..... i want to remove the back seats and build some kind of storage (tools tow rope normal stuff) on the floor then level the top to fit flush with trunk.. Has any one seen this before? Pics would be great even if its just to show me how to take the seat off any thing helps gentleman which you probably already know. Thanks in advance and im going to clean the garage tomorrow take that old fridge set it up in the garage and run a new circut there for my air compressor as well.

Author:  KJ 119 [ Sat Jul 19, 2008 7:31 am ]
Post subject: 

Check the "fabrication" section.
A couple of guys modified the back seat area.

Author:  tommudd [ Sat Jul 19, 2008 10:04 am ]
Post subject: 

been done , easy to do, I even have the whole plywood thing I did in the rafters of the garage if you need some measurements

Author:  Freshmud [ Sat Jul 19, 2008 11:15 pm ]
Post subject: 

tommudd wrote:
been done , easy to do, I even have the whole plywood thing I did in the rafters of the garage if you need some measurements


yeah man that would be great i removed the seat today and all that but now im tryin to take out the trunk carpet and cant get it off those tie down points.... Any thing i should be aware of or how do i remove those? ao yeah and i wanna take off all the paneling in the back to i can clean them intensly.....pretty much i wanna tear the jeep apart take out what i dont like fix it and rebuild it :twisted:

Author:  tjkj2002 [ Sat Jul 19, 2008 11:35 pm ]
Post subject: 

Freshmud wrote:
tommudd wrote:
been done , easy to do, I even have the whole plywood thing I did in the rafters of the garage if you need some measurements


yeah man that would be great i removed the seat today and all that but now im tryin to take out the trunk carpet and cant get it off those tie down points.... Any thing i should be aware of or how do i remove those? ao yeah and i wanna take off all the paneling in the back to i can clean them intensly.....pretty much i wanna tear the jeep apart take out what i dont like fix it and rebuild it :twisted:
A drill and a 1/4" drill bit to drill the 2 rivets holding each of the tie-downs in place.

Author:  Freshmud [ Sat Jul 19, 2008 11:38 pm ]
Post subject: 

so what exactly do i do then?? sorry this jeep is my first and im still learning

Author:  tjkj2002 [ Sun Jul 20, 2008 12:00 am ]
Post subject: 

Freshmud wrote:
so what exactly do i do then?? sorry this jeep is my first and im still learning
Drill the heads of the rivets off then pull the tie-downs up.

Author:  Fulltimer [ Sun Jul 20, 2008 12:05 am ]
Post subject: 

After you drill out the little buggers be sure to seal the holes up good so water/dust etc doesn't get in. I used a dab of silicone sealant on mine.

Terry

Author:  dirtykj [ Sun Jul 20, 2008 1:24 am ]
Post subject: 

You'll find a lot of those rivets in the KJ. The kind you have to drill to get them out, and of course you hope you have replacements handy :) If not, go to NAPA and buy a couple of boxes.

Author:  mrkake [ Sun Jul 20, 2008 2:28 am ]
Post subject: 

Here's the link:

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=29777

Author:  Freshmud [ Tue Jul 22, 2008 7:50 pm ]
Post subject: 

im gonna be getting pictures up hopefully later tonight.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/