| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Where to get fender flares? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=3677 |
Page 1 of 1 |
| Author: | Myke [ Thu Nov 24, 2005 4:11 pm ] |
| Post subject: | Where to get fender flares? |
I like the renegade flares. I have an 02 Limited If I got 02 Renegade flares would they just "bolt up" or is the body totally diff? How much do you think it would cost? |
|
| Author: | chemguy [ Thu Nov 24, 2005 5:22 pm ] |
| Post subject: | |
They would fit...just snap right on then pop the plastic rivets on the inner flare...done. www.jparts.com |
|
| Author: | Skyjump136 [ Thu Nov 24, 2005 6:00 pm ] |
| Post subject: | |
More specifically... http://www.jparts.com/catalog/product_i ... 371644b6e1 $233.75 shipped. |
|
| Author: | FreedomKJ [ Thu Nov 24, 2005 9:04 pm ] |
| Post subject: | |
You'll need to get them painted as they come flat black, and you'll need some plastic rivets and a rivet gun to install them (the bolts are fake.) |
|
| Author: | Myke [ Fri Nov 25, 2005 12:50 am ] |
| Post subject: | |
Thanks, I know the bolts are fake, so I searched napa for the rivets but couldn't find anything. Anyone have a direct link? |
|
| Author: | pixeldzn [ Fri Nov 25, 2005 1:22 am ] |
| Post subject: | |
Myke wrote: Thanks, I know the bolts are fake, so I searched napa for the rivets but couldn't find anything. Anyone have a direct link?
I had to replace my front bumper due to an accident. I had better luck finding the proper rivets here: http://www.thefastenerwarehouse.com NAPA didn't have anything like what I needed. You will have to look at the rivets on your vehicle now - maybe remove one of them and then measure and find the proper ones at the website. I was looking for the metal ones used on the bumper vs. the plastic ones used on the flares. The metal ones ended up being labeled as honda bumper rivets or something similar, so don't only look for domestic stuff. In any case, I bet they will have what you need. As an added note, I believe plastic rivets require a sepcial different rivet tool than metal ones do. Hope that helps! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|