It is currently Tue Aug 25, 2026 6:38 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 14 posts ] 
Author Message
 Post subject: Shaking steering wheel
PostPosted: Wed Oct 15, 2008 7:56 am 
Offline
LOST Member

Joined: Sun Feb 18, 2007 7:41 pm
Posts: 132
Location: Wyomissing, PA
All,

Good morning. Got a question - what would cause my steering wheel to shake at highway speeds? The Jeep does not shake only the steering wheel. I recently got it aligned and new tires went on it yesterday but still it shakes. What could it be? Thanks in advance.

-Dr. Dave


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 8:18 am 
have your front end checked.

IE tie rod ends.

What year/how many miles?

Could be a bent wheel


Top
  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 9:26 am 
Offline
LOST Addict
User avatar

Joined: Thu Aug 31, 2006 2:09 pm
Posts: 1297
Location: Minneapolis, MN
Rotors/discs might be warped.

_________________
"I'm the guy who does his job, you must be the other guy"
02 Black UNlimited Edition 4X4 Select Trac Liberty Towing/Off Road Packages 245/75/16 on black Moabs
RL diff cover/Super Skink sliders, Rusty's 2.5" Coil Lift w/ clevis lift, Roof basket W/Hella FF75...
On the prowl for an M416/M101/M100 trailer
L.O.S.T. Member 2877


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 11:16 am 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Fri Jun 09, 2006 2:30 pm
Posts: 2523
Location: LOST in Wisconsin
Most probable cause and easiest thing to check is tire balance. You probably through a wheel wieght or have extra mud or dirt caked on the rim.

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 12:09 pm 
Offline
LOST Member
User avatar

Joined: Sat Jul 09, 2005 1:30 pm
Posts: 243
Location: Milton Ontario. Canada
bugnout wrote:
Most probable cause and easiest thing to check is tire balance. You probably through a wheel wieght or have extra mud or dirt caked on the rim.


x2

_________________
Steve


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 6:15 pm 
Offline
LOST Member

Joined: Sun Feb 18, 2007 7:41 pm
Posts: 132
Location: Wyomissing, PA
Thanks for all the input! I have ruled out tire balance and alignment. Brake rotors could be warp - I have had dried mud jammed in the cooling vents for a while. As far as the tie rod goes, how can I determine if it/they are bent? Thanks in advance.

-Dr. Dave


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 8:57 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Sat Feb 17, 2007 7:26 pm
Posts: 1325
Location: Casper, Wyoming
They won't be bent, the ball sockets will be worn.

Have you checked the fluid level in the PS reservoir? Not really sure if that would cause a shimmy in the wheel and I'm sure it's the first thing you looked at but... well, ya never know.

Also another guess that I'm gonna ask the other pro's to interject their thoughts on: Could it be the rack bushings? I would think that would cause the Jeep to wander quite a bit.

_________________
Ron


"There are few problems in life the liberal application of duct tape can't solve."


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 10:31 pm 
wander, yes, shake, no.

If it was a brake rotor, it would only be under braking, not just cruising o nthe highway.


Top
  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 10:37 pm 
Offline
LOST Member

Joined: Mon Sep 29, 2008 11:59 pm
Posts: 193
Location: ashland N.H.
I have the same issue,and i have worn lower balljoints.2 sets of recall @ 85,000 miles.Monday putting MOOG serviceable in I'll keep ya posted...........

_________________
2005 greaser KJ,jeeper greaser


Top
 Profile  
 
 Post subject:
PostPosted: Wed Oct 15, 2008 10:41 pm 
lower balljoints will not cause a vibration either.

tie rod ends and wheels, or anything else that rotates. but as far as a steering wheel shake, that's about all that will cause it.

OP, how many miles on your rig?


Top
  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 6:41 am 
Offline
Moderator / Lifetime Member
Moderator / Lifetime Member

Joined: Thu Jul 07, 2005 5:49 pm
Posts: 27226
Location: NOW Southeastern Ohio/ Tanzania
ThunderbirdJunkie wrote:
lower balljoints will not cause a vibration either.

tie rod ends and wheels, or anything else that rotates. but as far as a steering wheel shake, that's about all that will cause it.

OP, how many miles on your rig?


right on, :wink:

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 7:34 am 
Offline
LOST Member

Joined: Sun Feb 18, 2007 7:41 pm
Posts: 132
Location: Wyomissing, PA
All,

Good morning and thanks for the input. Sorry for the lack of details in my question. My KJ is an '06 with ~33000 miles on it. The strange thing about the steering wheel shaking is that its the only thing shaking. If you take you hands off the wheel you feel nothing. Another strange thing is that it does not show up until everything "warms up". First think in the morning I pull onto the highway and there is no shaking. A few miles down the road it shows up. Any thoughts.

-Dr. Dave


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 9:11 am 
Offline
LOST Addict
User avatar

Joined: Thu Jul 07, 2005 2:11 pm
Posts: 1885
Location: Grand Rapids, MI
To check your tie rod ends, jack the one front tire up (by the LCA), and move the wheel/tire as if you were shaking it. And see if your tie rod moves, you can see it through the rim.

_________________
2002 Jeep KJ Sport 3.7L 4x4

245/75-16 Mastercraft Courser HSX, 16x7 Cragar, 2" OME MD Lift, ARB Bumper
AEM Brute Force Cold Air Intake, Flowmaster Super 44 Muffler

Currently working on: Full service on transmission & bed-lining ARB bumper

viewtopic.php?f=43&t=84650


Top
 Profile  
 
 Post subject:
PostPosted: Thu Oct 16, 2008 10:49 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Fri Jul 08, 2005 12:31 am
Posts: 1979
Location: Lower NY
I had a bad shimmy in the wheel at about 60-65 mph. I had recently put on 2 used front tires. They were balanced fine when they were installed but the shimmy disapeared when I changed to Revos.

_________________
My pics!!
'03 Rennie w/all Tupperware
Custom Roof Basket
Mopar Tubular Brush Guard
Garmin GPS V & Laptop w/Nav software
RAM products laptop mount
Maglite w/mount
Rear cargo bay tool cabinet
AllJs Rear Shelf
Rear receiver
250k miles!
LOST #CR051230


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 14 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com