LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

check engine light
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=36887		 Page 1 of 1
Author:  Sean150 [ Sat Oct 18, 2008 10:50 pm ]
Post subject:  check engine light
I can't seem to remember how to get my kj to display the error code on the dash, could someone please refresh my memory.
Author:  jsc7002 [ Sun Oct 19, 2008 12:55 am ]
Post subject: 
put the key in the ignition and go off-on-off-on-off-on and it should show where the odo is
Author:  SavageUrge [ Mon Oct 20, 2008 8:51 pm ]
Post subject: 
This doesn't work on my '03.
Author:  Guest [ Mon Oct 20, 2008 10:39 pm ]
Post subject: 
ON OFF ON OFF ON.

it will work, the only ones that are susceptible to the dealer TSB reflash that prevents you from pulling the code yourself is '05+

OR you actually have a transmission code.

or, if it doesn't work, you don't have a code. one of the two. when my '02 is CEL-less, it doesn't display anything but hte mileage on the third cycle.
Author:  SavageUrge [ Mon Nov 03, 2008 11:16 pm ]
Post subject: 
Even when my Jeep was displaying the CEL, I tried the ON-Off-ON-Off-ON trick and it didn't work. When I hooked up my code scanner I got the standard P0442 code for a small evap leak (NO- it wasn't the gas cap! :lol: ).
Author:  DryBones [ Tue Nov 04, 2008 12:11 am ]
Post subject: 
ThunderbirdJunkie wrote:
ON OFF ON OFF ON.

it will work, the only ones that are susceptible to the dealer TSB reflash that prevents you from pulling the code yourself is '05+

OR you actually have a transmission code.

or, if it doesn't work, you don't have a code. one of the two. when my '02 is CEL-less, it doesn't display anything but hte mileage on the third cycle.


worked on my 05 last time I had a CEL.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/